Power Conversion Enhancement of CdS/CdTe Solar Cell Interconnected with Tunnel Diode

作     者：Wagah F. Mohammed Omar Daoud Munther Al-Tikriti 

作者机构：Communications and Electronics Department Faculty of Engineering Philadelphia University Amman Jordan 

出 版 物：《Circuits and Systems》 (电路与系统（英文）)

年 卷 期：2012年第3卷第3期

页      面：230-237页

学科分类：0808[工学-电气工程] 08[工学] 

主　　题：CdS/CdTe Solar Cells Energy Conversion Efficiency 

摘      要：One of the most promising solar cell devices is cadmium telluride (CdTe) based. These cells however, have their own problems of stability and degradation in efficiency. Measurements show that CdS/CdTe solar cell has high series resistance which degrades the performance of solar cell energy conversion. Both active layers (CdS and CdTe) had been fabricated by thermal evaporation and tested individually. It was found that CdS window layer of 300 nm have the lowest series resistance with maximum light absorption. While 5 - 7 μm CdTe absorber layer absorbed more than 90% of the incident light with minimum series resistance. A complete CdS/CdTe solar cell was fabricated and tested. It was found that deposited cell without heat treatment shows that the short circuit current increment decreases as the light intensity increases. This type of deposited cell has low conversion efficiency. The energy conversion efficiency was improved by heat treatment, depositing heavily doped layer at the back of the cell and minimizing the contact resistivity by depositing material with resistivity less than 1 m??cm2. All these modifications were not enough because the back contact is non-ohmic. Tunnel diode of CdTe (p++)/CdS (n++) was deposited in the back of the cell. The energy conversion efficiency was improved by more than 7%.