检索结果-南通市图书馆

Plasmon-phonon coupling in graphene-hyperbolic bilayer heterostructures

在线全文

学校读者我要写书评

暂无评论

Chinese Physics B 2016年第11期25卷 324-332页

作者：尹格元军姜玮朱剑飞马云贵 State Key Laboratory of Modern optical Instrumentation Center for Optical and Electromagnetic ResearchCollege of Optical Science and Engineering Zhejiang University

Polar dielectrics are important optical materials enabling the subwavelength manipulation of light in infrared due to their capability to excite phonon *** practice,it is highly desired to actively modify these hyperbolic phonon polaritons（HPPs） to optimize or tune the response of the *** this work,we investigate the plasmonic material,a monolayer graphene,and study its hybrid structure with three kinds of hyperbolic thin films grown on SiO_2 *** inter-mode hybridization and their tunability have been thoroughly clarified from both the band dispersions and the mode patterns numerically calculated through a transfer matrix *** results show that these hybrid multilayer structures are of strong potentials for applications in plasmonic waveguides,modulators and detectors in infrared.

关键词： hyperbolic phonon desired clarified multilayer Polar enabling manipulation infinite optimize

Improved partial response maximum likelihood method combining modulation code for signal waveform modulation multi-level disc

在线全文

学校读者我要写书评

暂无评论

Chinese Physics B 2014年第10期23卷 213-219页

作者：王鹤群裴京潘龙法 optical Memory National Engineering research center Tsinghua University

In this paper, we describe an improved adaptive partial response maximum likelihood （PRML） method combining modulation code tbr signal waveform modulation multi-level disc. This improved adaptive PRML method employs partial response equalizer and adaptive viterbi detector combining modulation code. Compared with the traditional adaptive PRML detector, the improved PRML detector additionally employs illogical sequence detector and corrector. Illogical sequence detector and corrector can aw）id the appearance of illogical sequences effectively, which do not follow the law of modulation code for signal waveform modulation multi-level disc, and obtain the correct sequences. We implement the improved PRML detector using a DSP and an FPGA chip. The experimental results show good performance. The higher efficient and lower complexity can be obtained by using the improved PRML method than by using the previous PRML method. Meanwhile, resource utilization of the improved PRML detector is not changed, but the bit error rate （BER） is reduced by more than 20%.

关键词： multi-level disc signal waveform modulation viterbi detector partial response maximum likeli-hood

Measurement of bidirectional reflection distribution function on material surface

在线全文

学校读者我要写书评

暂无评论

Chinese Optics Letters 2009年第1期7卷 88-91页

作者：张伟汪洪源王治乐 research center for Space optical Engineering Harbin Institute of Technology

Two automatic measurement methods of bidirectional reflection distribution function （BRDF） are presented based on absolute and relative definition. Measurement principle and scheme of the methods are analyzed. A real-time measurement device is developed, the measurement spectral range of which is from ultraviolet to near infrared with 2.4-nm wavelength resolution, and the angular range is 0° - 360° in azimuth angle and 0° - 85° in zenith angle with 0.01° angle resolution. Absolute measurements of BRDF on tinfoil and ceramic tile are performed and the test materials present apparent specular reflection characteristics. The theoretical error in the experiment is about 6.05%. The BRDF measurement results are closely related to the precision of measurement platform, the sensitivity of measurement instrument, and the stability of illuminating light source.

关键词： Distribution functions Fabrics Light Light sources Lighting Probability density function Reflection Time measurement

Read channel for signal waveform modulation multi-level disc

在线全文

学校读者我要写书评

暂无评论

Chinese Physics B 2010年第12期19卷 334-338页

作者：王鹤群徐海峥潘龙法刘海龙 optical Memory National Engineering research center Tsinghua University

A novel read channel for signal waveform modulation multi-level disc is presented in this paper. This read channel employs timing recovery system and partial response maximum likelihood detector. Compared to the previous read channel composed of level detection and run-length detection, the present read channel shows superiority in capacity increase and robust performance. Especially, relying on the partial response maximum likelihood detection, lower bit error rate can be obtained.

关键词： multi-level disc signal waveform modulation read channel partial response maximum likelihood

Investigations of range accuracy for long-range three-dimensional active imaging

在线全文

学校读者我要写书评

暂无评论

Chinese Optics Letters 2011年第6期9卷 48-50页

作者：张秀达严惠民周琴 State Key Laboratory of Modern optical Instrument National Engineering Research Center for Optical Instrument Optical Engineering Department Zhejiang University

Distance resolutions and noises are analyzed experimentally for long-range three-dimensional （3D） active imaging systems that have signal-to-noise ratios （SNRs） more optimal than 30：1. Findings indicate that the photon shot noise primarily determines the SNR. However, the active imaging method, which has a relatively low SNR, generates a relatively high distance resolution. To explain this phenomenon, a theory in which the distance resolution of 3D active imaging systems is determined by both the photon shot noise and the subinterval width is developed. Theoretical and experimental results differ by less than 4%.

关键词： Imaging systems Photons Shot noise Signal to noise ratio

Effect of structural parameters of Gaussian repaired pit on light intensity distribution inside KH_2PO_4 crystal

在线全文

学校读者我要写书评

暂无评论

Chinese Physics B 2014年第8期23卷 540-547页

作者：肖勇陈明君程健廖威王海军李明全 center for Precision Engineering Harbin Institute of Technology Chengdu Fine optical Engineering research center

KH2PO4 （KDP） crystal with excellent optical properties is a very important element of inertial confinement fusion （ICF） device. However, KDP crystal surface micro-defects severely reduce the crystal laser damage threshold, affecting the crystal service life. In this paper, Gaussian repaired pit is used to replace the crystal surface micro-defects, in order to improve the laser damage resistance of the KDP crystal with surface micro-defects. At first, the physical model of Gaussian repaired pit is built by Fourier model method, and the accuracy of the method is analyzed. It is found that the calculation error can be reduced by increasing the product of the width-period ratio and the truncation constant of the repaired pit. The calculation results about the physical model of Gaussian repaired pit show that the light intensity distribution within the crystal is symmetrical, and there are evidently enhanced light intensity regions in the crystal. Meanwhile, the maximum relative intensity inside the KDP crystal decreases gradually with the increase of the width of the Gaussian repaired pit. Secondly, the Gaussian repaired pits with different widths and the same depth of 20 μm are processed by micro-milling. Their surfaces are very smooth and present the ductile cutting state under the microscope. Finally, the laser damage threshold of the Gaussian repaired pits on the surface of the KDP crystal sample is measured by a 3 ω, 6-ns laser. The results showthat the maximum threshold of the Gaussian repaired pits is 3.12 J/cm2, which is 60% higher than the threshold of initial damage point, and the laser damage threshold increases with the increase of the width of the Gaussian repaired pit.

关键词： KH2PO4 Gaussian repaired pit Fourier modal method laser damage threshold

Silicon nanophotonics for on-chip light manipulation

在线全文

学校读者我要写书评

暂无评论

Chinese Physics B 2018年第10期27卷 46-57页

作者： Jingshu Guo Daoxin Dai center for optical and Electromagnetic research State Key Laboratory for Modern Optical InstrumentationCollege of Optical Science and EngineeringZhejiang UniversityHangzhou 310058China

The field of silicon nanophotonics has attracted considerable attention in the past decade because of its unique advantages,including complementary metal–oxide–semiconductor（CMOS） compatibility and the ability to achieve an ultra-high integration density. In particular, silicon nanophotonic integrated devices for on-chip light manipulation have been developed successfully and have played very import roles in various applications. In this paper, we review the recent progress of silicon nanophotonic devices for on-chip light manipulation, including the static type and the dynamic type. Static onchip light manipulation focuses on polarization/mode manipulation, as well as light nanofocusing, while dynamic on-chip light manipulation focuses on optical modulation/switching. The challenges and prospects of high-performance silicon nanophotonic integrated devices for on-chip light manipulation are discussed.

关键词： silicon nanophotonics polarization mode manipulation nanoplasmonics optical modulator optical switch.

Mechanism of micro-waviness induced KH_2PO_4 crystal laser damage and the corresponding vibration source

在线全文

学校读者我要写书评

暂无评论

Chinese Physics B 2012年第5期21卷 34-42页

作者：李明全陈明君安晨辉周炼程健肖勇姜伟 center for Precision Engineering Harbin Institute of Technology Chengdu Fine optical Engineering research center

The low laser induced damage threshold of the KH2PO4 crystal seriously restricts the output power of inertial confinement *** micro-waviness on the KH2PO4 surface processed by single point diamond turning has a significant influence on the damage *** this paper,the influence of micro-waviness on the damage threshold of the KH2PO4 crystal and the chief sources introducing the micro-waviness are analysed based on the combination of the Fourier modal theory and the power spectrum density *** results indicate that among the sub-wavinesses with different characteristic spatial frequencies there exists the most dangerous frequency which greatly reduces the damage threshold,although it may not occupy the largest proportion in the original *** experimental damage threshold is basically consistent with the theoretical *** the processing parameters used,the leading frequency of micro-waviness which causes the damage threshold to decrease is between 350-1 μm-1 and 30-1 μm-1,especially between 90-1 μm-1 and 200-1 μ*** on the classification study of the time frequencies of microwaviness,we find that the axial vibration of the spindle is the chief source introducing the micro-waviness,nearly all the leading frequencies are related to the practical spindle frequency（about 6.68 Hz,400 r/min） and a special middle frequency（between 1.029 Hz and 1.143 Hz）.

关键词： laser induced damage threshold micro-waviness Fourier modal theory power spectrum density

Ultrahigh-Q silicon racetrack resonators

在线全文

学校读者我要写书评

暂无评论

Photonics research 2020年第5期8卷 684-689页

作者： LONG ZHANG LANLAN JIE MING ZHANG YI WANG YIWEI XIE YAOCHENG SHI DAOXIN DAI State Key Laboratory for Modern optical Instrumentation Center for Optical&Electromagnetic ResearchCollege of Optical Science and EngineeringInternational Research Center for Advanced PhotonicsZhejiang UniversityHangzhou 310058China Ningbo research Institute Zhejiang UniversityNingbo 315100China

An ultrahigh-Q silicon racetrack resonator is proposed and demonstrated with uniform multimode silicon photonic *** consists of two multimode straight waveguides connected by two multimode waveguide bends(MWBs).In particular,the MWBs are based on modified Euler curves,and a bent directional coupler is used to achieve the selective mode coupling for the fundamental mode and not exciting the higher-order mode in the *** this way,the fundamental mode is excited and propagates in the multimode racetrack resonator with ultralow loss and low intermode ***,it helps achieve a compact 180°bend to make a compact resonator with a maximized free spectral range(FSR).In this paper,for the chosen 1.6μm wide silicon photonic waveguide,the effective radius Reffof the designed 180°bend is as small as 29μ*** corresponding FSR is about 0.9 nm when choosing 260μm long straight waveguides in the *** present high-Q resonator is realized with a simple standard single-etching process provided by a multiproject wafer *** fabricated device,which has a measured intrinsic Q-factor as high as 2.3×10~6,is the smallest silicon resonator with a>106Q-factor.

关键词： resonator waveguide mode