检索结果-南通市图书馆

Regeneration of waste SCR catalyst by air lift loop reactor

在线全文

学校读者我要写书评

暂无评论

Journal of Central South University 2013年第5期20卷 1314-1318页

作者： LEE Jung-bin EOM yong-seok kim Jun-han CHUN Sung-nam Technology Commercialization Office Korea Electric Power Research Institute

A solution of 0.1 mol/L to 1.0 mol/L H2SO4 can dissolve alkali metals and alkaline earth metals which weaken an active site of SCR catalyst. The waste catalyst washed with 0.5 mol/L H2SO4 regained the best catalytic activity. When a concentration of the sulfuric acid is less than 0.5 mol/L, sufficient cleaning effects cannot be obtained. In contrast, when the concentration is greater than 1.0 tool/L, the active components, vanadium and tungsten are undesirably eluted. The total BET surface of the catalyst regenerated by air lift loop reactor showed almost the same as that of fresh catalyst due to the removal of insoluble compounds which may be penetrated into pores of catalyst. The addition of a solution of 0.075 mol/L ammonium vanadate （NHnVO3） and 0.075 mol/L ammonium paratungstate （5（NH4）20· 12WO3-5H20） to 0.1 mol/L H2SO4 significantly increases the activity of the waste catalyst.

关键词： nitrogen oxide regeneration selective catalyst reduction air lift loop reactor catalyst

Suggestion of advanced regression model on friction angle of fault gouge in South Korea

在线全文

学校读者我要写书评

暂无评论

Journal of Rock Mechanics and Geotechnical Engineering 2021年第6期13卷 1368-1379页

作者： Seong-Woo Moon Hyun-seok Yun yong-seok Seo Department of Earth and Environmental Sciences Chungbuk National University1 Chungdae-roCheongju-siChungcheongbuk-do28644South Korea

Although friction characteristics of fault gouge are important to understand reactivation of fault,behavior of earthquake,and mechanism of slope failure,analysis results of fault gouge have low accuracy mostly than those of soils or rocks due to its high heterogeneity and low ***,to improve the accuracy of analysis results,we conducted simple regression analysis and structural equation model analysis and selected major influential factors of friction characteristics among many factors,and then we deduced advanced regression model with the highest coefficient of determination(R^(2)) via multiple regression *** most coefficients of determination in simple regression analysis are below0.3-0.4,coefficient of determination in multiple regression analysis is remarkably large as 0.657.

关键词： Fault gouge Friction angle Simple regression analysis Structural equation model analysis Multiple regression analysis

Asymmetric optical camouflage:tuneable reflective colour accompanied by the optical Janus effect

在线全文

学校读者我要写书评

暂无评论

Light(Science & Applications) 2020年第1期9卷 325-334页

作者： Taehyun kim Eui-Sang Yu Young-Gyu Bae Jongsu Lee In Soo kim seok Chung Seung-Yeol Lee yong-Sang Ryu Sensor System Research Center Korea Institute of Science and TechnologySeoul 02792Republic of Korea Department of Micro/Nano Systems Korea UniversitySeoul 02841Republic of Korea School of Electronic and Electrical Engineering Kyungpook National UniversityDaegu 41566Republic of Korea Nanophotonics Research Center Korea Institute of Science and TechnologySeoul 02792Republic of Korea School of Mechanical Engineering Korea UniversitySeoul 02841Republic of Korea

Going beyond an improved colour gamut,an asymmetric colour contrast,which depends on the viewing direction,and its ability to readily deliver information could create opportunities for a wide range of applications,such as nextgeneration optical switches,colour displays,and security features in anti-counterfeiting ***,we propose a simple Fabry–Perot etalon architecture capable of generating viewing-direction-sensitive colour contrasts and encrypting pre-inscribed information upon immersion in particular solvents(optical camouflage).Based on the experimental verification of the theoretical modelling,we have discovered a completely new and exotic optical phenomenon involving a tuneable colour switch for viewing-direction-dependent information delivery,which we define as asymmetric optical camouflage.

关键词： asymmetric generating readily

DC Motor Speed Regulator via Active Damping Injection and Angular Acceleration Estimation Techniques

维普期刊数据库评论

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

IEEE/CAA Journal of Automatica Sinica 2021年第3期8卷 641-647页

作者： seok-Kyoon kim Choon Ki Ahn Department of Creative Convergence Engineering Hanbat National UniversityDaejeon 341-58Republic of Korea School of Electrical Engineering Korea UniversitySeoul 136-701Republic of Korea

This paper suggests a novel model-based nonlinear DC motor speed regulator without the use of a current *** current dynamics,machine parameters and mismatched load variations are *** proposed controller is designed to include an active damping term that regulates the motor speed in accordance with the first-order low-pass filter dynamics through the pole-zero ***,the angular acceleration and its reference are obtained from simple first-order estimators using only the speed *** effectiveness is experimentally verified using hardware comprising the QUBEServo2,myRIO-1900,and LabVIEW.

关键词： Active damping injection angular acceleration estimator DC motor(DCM) speed regulation

The contribution of gender and age on early and late mortality following ST-segment elevation myocardial infarction： results from the Korean Acute Myocardial Infarction National Registry with Registries

在线全文

学校读者我要写书评

暂无评论

Journal of Geriatric Cardiology 2018年第3期15卷 205-214页

作者： Ae-Young Her Etm-seok Shin yong Hoon kim Scot Garg Myung Ho Jeong Division of Cardiology Department of Internal Medicine Kangwon National University School of Medicine Chuncheon South Korea Department of Cardiology Ulsan University Hospital University of Ulsan College of Medicine Ulsan Republic of Korea East Lancashire Hospitals NHS Trust Blackburn Lancashire UK The Heart Center of Chonnam National University Hospital Gwangju Republic of Korea

Background Although previous studies using Korean data have already reported higher rates of mortality in women, it is less clear whether these gender differences in prognosis post ST-segment elevation myocardial infarction （STEMI）, are age dependent. The aim of this study is to examine the gender-age interaction with early and late mortality in patients with STEMI enrolled in the Korean nationwide regis-try. Methods This prospective study stratified outcomes according to gender and age from 17,021 STEMI patients. We compared in-hospital, early （30 days） and late （12 months） mortality between gender to examine the gender-age interaction in multivariable models. Results In younger women （〈 60 years）, in-hospital [5.8% vs. 2.5%, P 〈 0.001; unadjusted odds ratios （OR）： 2.41, 95% confidence inter-vals （CI）： 1.59-3.66], early （6.2% vs. 2.6%, P 〈 0.001; unadjusted OR： 2.4, 95% CI： 2.12-2.72） and late mortality （7.0% vs. 3.1%, P 〉 0.001; unadjusted OR： 2.33, 95% CI： 2.08-2.61） were significantly higher compared with men. However, after adjustment for patient characteristics, Killip class ≥ 3, symptom to balloon time and major bleeding, and in-hospital bleeding, overall early and late mortality were no longer re-lated to gender in any age groups. Conclusions Among a Korean population with STEMI, higher early and late mortality in younger women may be explained by poor patient characteristics, higher Killip class ≥3, longer symptom to balloon time and more frequent major bleeding. Therefore, based on gender-age differences, more precise and aggressive preventive strategies focused on risk factor reduction, education and more intensive management for yotmger women should be performed.

关键词： Age Gender Mortality ST-segment elevation myocardial infarction

Spectrum of final pathological diagnosis of gastric adenoma after endoscopic resection

在线全文

学校读者我要写书评

暂无评论

World Journal of Gastroenterology 2011年第47期17卷 5177-5183页

作者： Kwan Woo Nam Kyu Sang Song Heon Young Lee Byung seok Lee Jae Kyu Seong seok Hyun kim Hee seok Moon Eaum seok Lee Hyun yong Jeong Gastroenterology Center Sun Hospital Pathologic Department Chung-Nam National University Hospital Gastroenterology Unit of Internal Medicine Department Chung-Nam National University Hospital

AIM: To investigate how many discrepancies occur in patients before and after endoscopic treatment of referred adenoma and the reason for these results. METHODS: We retrospectively reviewed data from 554 cases of 534 patients who were referred from primary care centres for adenoma treatment and treated for endoscopic mucosal resection (EMR) or endoscopic submucosal dissection (ESD) at Chungnam National University Hospital, from July 2006 to June 2009. Reendoscopy was examined in 142 cases and biopsywas performed in 108 cases prior to treatment. Three endoscopists (1, 2 and 3) performed all EMRs or ESDs and three pathologists (1, 2 and 3) diagnosed most of the cases. Transfer notes, medical records and endoscopic pictures of these cases were retrospectively reviewed and analyzed. RESULTS: Adenocarcinoma was 72 (13.0%) cases in total 554 cases after endoscopic treatment of referred adenoma. When the grade of dysplasia was high (55.0%), biopsy number was more than three (22.7%), size was no smaller than 2.0 cm (23.2%), morphologic type was depressed (35.8%) or yamada type Ⅳ (100%), and color was red (30.9%) or mixed-or-undetermined (25.0%), it had much more malignancy rate than the others (P < 0.05). All 18 cases diagnosed as adenocarcinoma in the re-endoscopic forceps biopsy were performed by endoscopist 1. There were different malignancy rates according to the pathologist (P = 0.027). CONCLUSION: High grade dysplasia is the most important factor for predicting malignancy as a final pathologic diagnosis before treating the referred gastric adenoma. This discrepancy can occur mainly through inappropriately selecting a biopsy site where cancer cells do not exist, but it also depends on the pathologist to some extent.

关键词： Discrepancy Adenoma High grade dyspla-sia Endoscopic mucosal resection Endoscopic submu-cosal dissection

Laser-assisted deposition of Cu bumps for microelectronic packaging

维普期刊数据库评论

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

中国有色金属学会会刊：英文版 2012年第S3期22卷 683-687页

作者： Won-seok CHOI Joohan kim Department of Nano IT Fusion Program Seoul National University of Science and Technology Department of Mechanical and Automotive Engineering Seoul National University of Science and Technology

Cu bump was transferred using a focused laser pulse for microelectronic *** Nd:YAG laser pulse (maximum energy of 500 mJ;wavelength of 1064 nm;fluences of 0.4-2.1 kJ/cm2) was irradiated on a sacrificial absorption layer with copper *** focused laser beam induced plasma between the semi-transparent donor slide and the sacrificial layer,causing a shock *** shock wave pressure pushed the Cu layer and transferred material to deposit a bump on substrate.A beam-shaper was used to produce uniform pressure at the interface to reduce fragmentation of the transferred material on the *** calculated shock wave pressure with respect to laser fluence was 1-3 GPa.A Cu bump of diameter of 200 μm was successfully deposited at laser fluence of 0.6 kJ/cm *** pressure control at the sacrificial layer using a laser pulse was critical to produce a bump with less *** technique can be applied to forming Cu bump for an interconnecting process in electronics.

关键词： laser induced forward transfer bump deposition Nd:YAG pulsed laser micro system packaging beam shaping

Corrosion characteristics of steel in seawater containing various chloride concentrations generated by electrochemical method

在线全文

学校读者我要写书评

暂无评论

中国有色金属学会会刊：英文版 2009年第B9期19卷 50-55页

作者： Seong-Jong kim seok-Ki JANG Division of Marine Engineering Mokpo Maritime University

The electro-clean system (ECS), a ballast water management system that eliminates harmful aquatic organisms in ship ballast water via electrochemically produced chloride, was developed. The current density for potentiostatic experiments subjected to seawater with an applied potential (-0.1 V) at various TRC concentrations (2×10-6, 6×10-6, 10×10-6, and 15×10-6) have similar results. The current density at -0.1 V has the highest value compared with that at -0.7 V and -0.4 V. For all concentrations, the current density increases with increasing applied potential.

关键词：含氯化物电化学方法腐蚀特性浓度海水船舶压载水钢铁电流密度

Enhancement of ballistic performance enabled by transformation-induced plasticity in high-strength bainitic steel

在线全文

学校读者我要写书评

暂无评论

Journal of Materials Science & Technology 2021年第25期84卷 219-229页

作者： Min Cheoljo Selim kim Dong Woo Suh Hong Kyu kim yongjin kim seok Su Sohn Sunghak Lee Center for Advanced Aerospace Materials Pohang University of Science and TechnologyPohang37673South Korea Graduate Institute of Ferrous Technology Pohang University of Science and TechnologyPohang37673South Korea Materials Directorate Agency for Defense DevelopmentDaejeon305-600South Korea Department of Materials Science and Engineering Korea UniversitySeoul02841South Korea

High-strength bainitic steels have created a lot of interest in recent times because of their excellent combination of strength,ductility,toughness,and high ballistic mass *** steels have great potential in the fabrication of steel armor *** various approaches and methods have been conducted to utilize the retained austenite(RA)in the bainitic matrix to control mechanical properties,very few attempts have been conducted to improve ballistic performance utilizing transformationinduced plasticity(TRIP)*** this study,high-strength bainitic steels were designed by controlling the time of austempering process to have various volume fractions and stability of RA while maintaining high *** dynamic compressive and ballistic impact tests were conducted,and the relation between the effects of TRIP on ballistic performance and the adiabatic shear band(ASB)formation was *** results show for the first time that an active TRIP mechanism achieved from a large quantity of metastable RA can significantly enhance the ballistic performance of high-strength bainitic steels because of the improved resistance to ASB ***,the ballistic performance can be effectively improved by a very short austempering time,which suggests that the utilization of active TRIP behavior via tuning RA acts as a primary mechanism for significantly enhancing the ballistic performance of high-strength bainitic steels.

关键词： High-strength bainitic steel Ballistic performance Split Hopkinson pressure bar(SHPB) Adiabatic shear band(ASB) Retained austenite(RA) Transformation-induced plasticity(TRIP)