Experimental study on the wear evolution of different PVD coated tools under milling operations of LDX2101 duplex stainless steel

作     者：Vitor F.C.Sousa Francisco J.G.Silva Ricardo Alexandre Jose S.Fecheira Gustavo Pinto Andresa Baptista Vitor F.C.Sousa;Francisco J.G.Silva;Ricardo Alexandre;José S.Fecheira;Gustavo Pinto;Andresa Baptista

作者机构：ISEP-School of EngineeringPolytechnic of PortoRua Dr.António Bernardino de Almeida4314200–072PortoPortugal INEGI-Driving Science and InnovationRua Dr.Roberto Frias4004200–465PortoPortugal TEandM-TechnologyEngineering and MaterialsS.A.Parque Industrial do TaveiroLotes 41-423045–504TaveiroPortugal 

出 版 物：《Advances in Manufacturing》 (先进制造进展（英文版）)

年 卷 期：2023年第11卷第1期

页      面：158-179页

核心收录：

学科分类：08[工学] 080502[工学-材料学] 0805[工学-材料科学与工程（可授工学、理学学位）] 

基　　金：The present work was done and funded under the scope of the project ON-SURF(ANI|P2020|POCI-01-0247-FEDER-024521 co-funded by Portugal 2020 and FEDER through COMPETE 2020-Operational Programme for Competitiveness and Internationalisation 

主　　题：Duplex stainless-steel Milling Tool coatings Surface roughness Wear mechanisms 

摘      要：Duplex stainless steels are being used on applications that require,especially,high corrosion resistance and overall good mechanical properties,such as the naval and oil-gas exploration *** components employed in these industries are usually obtained by machining,however,these alloys have low machinability when compared to conventional stainless *** this work,a study of the wear developed when milling duplex stainless-steel,LDX 2101,is going to be presented and evaluated,employing four types of milling tools with different geometries and coatings,while studying the influence of feed rate and cutting length in the wear of these *** used have been provided with two and four flutes,as well as three different coatings,namely:TiAlN,TiAlSiN and *** cutting behavior of these tools was analyzed;data relative to the cutting forces developed during the process were obtained;and roughness measurements of the machined surfaces were *** tools were then submitted to scanning electron microscope(SEM)analysis,enabling the identification of the wear mechanisms that tools were subjected to when machining this material,furthermore,the early stages of these mechanisms were also *** this work was done with the goal of relating the machining parameters and cutting force values obtained,identifying,and discussing the wear patterns that were observed in the coating and tools after the milling tests,providing further information on the machining of these alloys.