检索结果-南通市图书馆

Journal of Thermal Science 2021年第1期30卷 324-332页

作者： CHEN Zhen WEI Xiaolin LI Teng Key Laboratory for Thermal Science and Power Engineering of Ministry of Education Department of Energy and Power EngineeringTsinghua UniversityBeijing 100084China State Key Laboratory of High Temperature Gas Dynamics Institute of MechanicsChinese Academy of SciencesBeijing 100190China

An experimental study was carried out to investigate the flame characterization and temperature profile for single and multiple pool fire with the influence of cross *** were 13 test cases in total,categorized into circle and rectangle fuel pans,with diameter(or equivalent diameter)ranged from 50 mm to 300 *** was used for the fuel of pool *** K-type thermocouples were arranged around the flame to monitor the flame temperature,while the flame tilt angle was measured based on the photograph of flame for different ***,it can be found that there are three phases,including preheating,steady burning and extinguishing phase,during the flame *** maximum temperature near the fuel surface is~1040 K,which is higher than that of flame plume(~600 K),in the steady burning phase of circle single pool fire(D=300 mm),while the average burning rate is~1.525 g/*** addition,the burning rates of all cases were measured and compared with the current predicted ***,the flame morphology of single/multiple pool fire at different cross wind speed(ranging from 0 to 3.5 m/s)was analyzed,and it is found that the results for single pool fire agree with Thomas model and AGA model well,which are not suitable for multiple pool ***,the temperature profile of different case was measured with various wind speed.

关键词： pool fire temperature profile flame characteristic kerosene cross wind

Effect of landform on aerodynamic performance of high-speed trains in cutting under cross wind

在线全文

学校读者我要写书评

暂无评论

Journal of Central South University 2013年第3期20卷 830-836页

作者：刘堂红张洁 Key Laboratory of Traffic Safety on Track of Ministry of Education(Central South University) School of Traffic & Transportation Engineering Central South University

The effects of the different landforms of the cutting leeward on the aerodynamic performance of high-speed trains were analyzed based on the three-dimensional, steady, and incompressible Navier-Stokes equation and k-e double-equation turbulent model. Results show that aerodynamic forces increase with the cutting leeward slope decreasing. The maximum adding value of lateral force, lift force, and overturning moment are 147%, 44.3%, and 107%, respectively, when the slope varies from 0.67 to -0.67, and the changes in the cutting leeward landform have more effects on the aerodynamic performance when the train is running in the line No. 2 than in the line No. 1. The aerodynamic forces, except the resistance force, sharply increase with the slope depth decreasing. By comparing the circumstance of the cutting depth H=-8 m with that of H=8 m, the resistance force, lateral force, lift force, and overturning moment increase by 26.0%, 251%, 67.3% and 177%, respectively. With the wind angle increasing, the resistance force is nonmonotonic, whereas other forces continuously rise. Under three special landforms, the changes in the law of aerodynamic forces with the wind angle are almost similar to one another.

关键词： high-speed train cross wind special landform aerodynamic performance

Experimental Study of Effects of cross wind on Flow in Natural-draft Dry-cooling Towers

在线全文

学校读者我要写书评

暂无评论

Tsinghua Science and Technology 1998年第2期3卷 9-12页

作者：翟志强朱克勤符松

The effects of cross wind on the flow field in natural draft dry cooling towers are studied experimentally in a wind tunnel using similarity principles. Particular attention is focused on the flow fields inside the tower. The study illustrates the influence of wind on the cooling tower performance and proposes a number of techniques for improving tower performance with a cross wind

关键词： natural draft dry cooling tower cross wind aerodynamics model experiment

Detached-eddy simulation of flow around high-speed train on a bridge under cross winds

在线全文

学校读者我要写书评

暂无评论

Journal of Central South University 2016年第10期23卷 2735-2746页

作者：陈敬文高广军朱春丽 School of Traffic & Transportation Engineering Central South University Changsha 410075 China Key Laboratory of Traffic Safety on the Track of Ministry of Education (Central South University) Changsha 410075 China

In order to describe an investigation of the flow around high-speed train on a bridge under cross winds using detached-eddy simulation(DES), a 1/8th scale model of a three-car high-speed train and a typical bridge model are employed, Numerical wind tunnel technology based on computational fluid dynamics(CFD) is used, and the CFD models are set as stationary models. The Reynolds number of the flow, based on the inflow velocity and the height of the vehicle, is 1.9×10~6. The computations are conducted under three cases, train on the windward track on the bridge(WWC), train on the leeward track on the bridge(LWC) and train on the flat ground(FGC). Commercial software FLUENT is used and the mesh sensitivity research is carried out by three different grids: coarse, medium and fine. Results show that compared with FGC case, the side force coefficients of the head cars for the WWC and LWC cases increases by 14% and 29%, respectively; the coefficients of middle cars for the WWC and LWC increase by 32% and 10%, respectively; and that of the tail car increases by 45% for the WWC whereas decreases by 2% for the LWC case. The most notable thing is that the side force and the rolling moment of the head car are greater for the LWC, while the side force and the rolling moment of the middle car and the tail car are greater for the WWC. Comparing the velocity profiles at different locations, the flow is significantly influenced by the bridge-train system when the air is close to it. For the three cases(WWC, LWC and FGC), the pressure on the windward side of train is mostly positive while that of the leeward side is negative. The discrepancy of train's aerodynamic force is due to the different surface area of positive pressure and negative pressure zone. Many vortices are born on the leeward edge of the roofs. Theses vortices develop downstream, detach and dissipate into the wake region. The eddies develop irregularly, leading to a noticeably turbulent flow at leeward side of train.

关键词： detached-eddy simulation high speed train bridge cross wind flow structure train aerodynamics

Safety evaluation for railway vehicles using an improved indirect measurement method of wheel–rail forces

在线全文

学校读者我要写书评

暂无评论

Journal of Modern Transportation 2016年第2期24卷 114-123页

作者： Jing Zeng Lai Wei Pingbo Wu State Key Laboratory of Traction Power Southwest Jiaotong University

The wheel-rail force measurement is of great importance to the condition monitoring and safety evaluation of railway vehicles. In this paper, an improved indirect method for wheel-rail force measurement is proposed to evaluate the running safety of railway vehicles. In this method, the equilibrium equations of a suspended wheelset are derived and the wheel-rail forces are then be obtained from measured suspension and inertia forces. This indirect method avoids structural modifications to the wheelset and is applicable to the long-term operation of railway vehicles. As the wheel-rail lateral forces at two sides of the wheelset are difficult to separate, a new derailment criterion by combined use of wheelset derailment coefficient and wheel unloading ratio is proposed. To illustrate its effectiveness, the indirect method is applied to safety evaluation of rail- way vehicles in different scenarios, such as the cross wind safety of a high-speed train and the safety of a metro vehicle with hunting motions. Then, the feasibility of using this method to identify wheel-rail forces for low-floor light rail vehicles with resilient wheels is discussed. The values identified by this method is compared with that by Simpack simulation for the same low-floor vehicle, which shows a good coincidence between them in the time domain of the wheelset lateral force and the wheel-rail vertical force. In addition, use of the method to determine the high-frequency wheel-rail interaction forces reveals that it is possible to identify the high-frequency wheel-rail forces through the accelerations on the axle box.

关键词： Wheel-rail force Safety evaluation - Indirect method Union safety domain Wheelset derailment coefficient Hunting motions cross wind Low-floor vehicle