检索结果-南通市图书馆

Numerical Analysis of shock Induced separation Delay by Air Humidity

在线全文

学校读者我要写书评

暂无评论

Journal of Thermal science 2005年第2期14卷 120-125页

作者： Piotr DOERFFER slawomir dykas IMP PAN Fiszera 14 PL-80 952 GdanskPolandInstitute of Power Engineering and Turbomachinery Konarskiego 18PL-44 100 GliwicePoland

In this paper numerical calculations of the dry and humid air flows in the nozzle are presented. The dry air flow (adiabatic flow) and the humid air flow (flow with homogeneous condensation, diabatic flow) are modeled with the use of Reynolds Averaged Navier-stokes (RANs) equations. The comparison of these two types of flow is carried out. The influence of the air humidity on the shock wave location and its interaction with the boundary layer is examined. Obtained numerical results present a first numerical approach of the condensation and evaporation process in transonic flow of humid air. The phenomena considered here are very complex and complicated and need further in-depth numerical analysis.

关键词： shock wave condensation air-humidity.

Effect of Eu3+,Bi3+,and Li+ doping on luminescent property of GdNbO4

在线全文

学校读者我要写书评

暂无评论

Journal of Rare Earths 2024年第1期42卷 66-75页

作者： s.W.Wi Y.s.Lee Department of Physics and Integrative Institute of Basic sciences Soongsil University

We investigated the emission properties of Eu3+-doped GdNbO4-based oxide phosphors,aiming at improving the Eu3+emission by codoping of Bi3+and Li+.Eu3+singly doped,Eu3+and Bi3+doubly doped,and Eu3+,Bi3+,and Li+triply doped GdNbO4were prepared using a high-temperature solid-state reaction *** red-orange emissions from Eu3+in the singly doped samples are significantly improved by the codoping of Bi3+,mainly due to the energy transfer from Bi3+to Eu3+.The additional codoping of Li+is found to increase the Eu3+emission *** improvement might be attributed to the increase in the photoluminescent quantum yield originating from larger grain sizes and better crystallinity.A detailed analysis of the X-ray diffraction pattern and the asymmetric ratio estimated from the photoluminescence spectra show that the local lattice environment around Eu3+in GdNbO4does not change significantly with the codoping of Bi3+and Li+.Our results indicate that Li+doping is a promising way to improve the emission properties of rare-earth ion-doped GdNbO4phosphors.

关键词： Eu3+ GdNbO4 Codoping of Li+ Photoluminescence sensitizer Rare earths

First evidence for chiral wobbling of triaxial nuclei

在线全文

同方期刊数据库

学校读者我要写书评

暂无评论

Nuclear science and Techniques 2024年第7期35卷 4-7页

作者： s.Frauendorf Department of Physics and Astronomy University of Notre DameNotre DameIN 46556USA

Chirality(Greek“handiness”)is a property of many com-plex *** molecules exist in two forms,one being the mirror image of the *** for our hands,it is impossible to make the images identical by a suitable *** two forms are called left-handed and *** have the same binding energy,because the electro-magnetic interaction,which holds the molecule together,does not change under a *** properties that are insensitive to the geometry are also the *** different geometry is the reason why the left-handed form turns the polarization plane of transmitted light in one direction by some angle while the right-handed form turns it in the oppo-site direction by the same ***,the geometrical differences between the two species may have other *** two species of the carvon molecule shown in Fig.1 taste quite differently.

关键词： turns Chiral mirror

Tribological behavior of lubricant-impregnated porous polyimide

在线全文

学校读者我要写书评

暂无评论

Friction 2024年第4期12卷 711-725页

作者： Jinbang LI Ningning ZHOU Janet s.s.WONG school of Mechanical Engineering and Mechanics Ningbo UniversityNingbo 315211China Beijing Key Laboratory of Long-life Technology of Precise Rotation and Transmission Mechanisms Beijing Institute of Control EngineeringBeijing 100029China Department of Mechanical Engineering Imperial College LondonLondon SW72AZUK

Porous materials impregnated with lubricants can be used in conditions where limited lubricant is *** this work,three porous polyimides(PPI)with different densities were ***(PAO)impregnated PPI(iPPI)discs were rubbed against steel and sapphire *** operando observations of the iPPI-sapphire contacts show that oil is released under an applied load,forming a meniscus around *** at the outlet is created at high sliding *** amount of released oil increases with increasing PPI *** moduli,E*,estimated based on the actual contact size show that trapped oil in iPPIs contributes to load *** higher speeds,tribological rehydration of the contact occurs in low density iPPI,with that E*rises with *** high density PPIs,high speeds give a constantly high E*which is limited by the viscoelastic properties of the PPI network and possibly the rate of oil *** of iPPI-steel contacts is governed by the mechanical properties of the PPI,the flow of the lubricant,and the roughness of the PPI *** low-and medium-density(highly porous,high roughness)PPIs,large amount of oil is released,and lubrication is mainly via lubricant restricted in the contact in the pores and possibly tribological *** high density(low porosity)PPI,with lower roughness,hydrodynamic lubrication is achieved which gives the lowest *** results show that polymeric porous materials for effective lubrication require the optimization of its surface roughness,stiffness,oil flow,and oil retentions.

关键词： polyimide porous material friction mechanism polymer limited lubrication

Real prospects for the development of power technologies based on renewable energy sources in Poland

维普期刊数据库评论

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Frontiers in Energy 2017年第2期11卷 168-174页

作者： slawomir dykas Artur sZYMANsKI Xiaoshu CAI silesian University of Technology Institute of Power Engineering andTurbomachinery Konarskiego 20 44-100 Gliwice Poland Institute of Particle and Two-Phase Flow Measurement University ofShanghai for Science and Technology Shanghai 200093 China

In Poland more than 40% of the power units have been operating for over 40 years now and more than 10% are over 50 years old, which indicates a high degree of decrease in the value of the energy sector. An analysis of the energy market shows that every year a new power plant should be built with a capacity of 1000 MW to ensure the national energy security. An energy market research indicates that in Poland the structure of energy production is changing in recent years-the share of fossil (solid) fuels in electricity and heat production was approximately 88% in 2009, while in 2004 it reached 93%. According to the analysis of the market, it can be seen that conventional energy, mainly based on coal and lignite, has been the most important segment of the sector for a long time. In this paper the prospects for the development of power technologies based on renewable energy sources (REs) in Poland are presented.

关键词： renewable energy sources energy sector energy mix Poland

Enhancing fatigue performance of AZ31 magnesium alloy components fabricated by cold metal transfer-based wire arc directed energy deposition through LPB

维普期刊数据库评论

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Journal of Magnesium and Alloys 2024年第4期12卷 1638-1662页

作者： shambhu Kumar Manjhi srikanth Bontha A.s.s.Balan Department of Mechanical Engineering National Institute of Technology KarnatakaSurathkalSrinivasanagarMangaloreKarnataka 575025India

Cold Metal Transfer-Based Wire Arc Directed Energy Deposition(CMT-WA-DED)presents a promising avenue for the rapid fabrication of components crucial to automotive,shipbuilding,and aerospace ***,the susceptibility to fatigue of CMT-WA-DED-produced AZ31 Mg alloy components has impeded their widespread adoption for critical load-bearing *** this study,a comprehensive investigation into the fatigue behaviour of WA-DED-fabricated AZ31 Mg alloy has been carried out and compared to commercially available wrought AZ31 *** findings indicate that the as-deposited parts exhibit a lower fatigue life than wrought Mg alloy,primarily due to poor surface finish,tensile residual stress,porosity,and coarse grain microstructure inherent in the WA-DED *** Plasticity Burnishing(LPB)treatment is applied to mitigate these issues,which induce significant plastic deformation on the *** treatment resulted in a remarkable improvement of fatigue life by 42%,accompanied by a reduction in surface roughness,grain refinement and enhancement of compressive residual stress ***,during cyclic deformation,WA-DED specimens exhibited higher plasticity and dislocation density compared to both wrought and WA-DED+LPB specimens.A higher fraction of Low Angle Grain Boundaries(LAGBs)in WA-DED specimens contributed to multiple crack initiation sites and convoluted crack paths,ultimately leading to premature *** contrast,wrought and WA-DED+LPB specimens displayed a higher percentage of High Angle Grain Boundaries(HAGBs),which hindered dislocation movement and resulted in fewer crack initiation sites and less complex crack paths,thereby extending fatigue *** findings underscore the effectiveness of LPB as a post-processing technique to enhance the fatigue performance of WA-DED-fabricated AZ31 Mg alloy *** study highlights the importance of LPB surface treatment on AZ31 Mg components produced by CMT-WA-DED to remove surface d

关键词： Wire arc additive manufacturing AZ31 Mg alloy Low plasticity burnishing Low cycle fatigue test strain amplitude

Ren-integrable and ren-symmetric integrable systems

在线全文

学校读者我要写书评

暂无评论

Communications in Theoretical Physics 2024年第3期76卷 62-69页

作者： s Y Lou school of Physical science and Technology Ningbo UniversityNingbo315211China

A new type of symmetry,ren-symmetry,describing anyon physics and corresponding topological physics,is ***-symmetry is a generalization of super-symmetry which is widely applied in super-symmetric physics such as super-symmetric quantum mechanics,super-symmetric gravity,super-symmetric string theory,super-symmetric integrable systems and so *** and Grassmann numbers are,in some sense,dual conceptions,and it turns out that these conceptions coincide for the ren situation,that is,a similar conception of ren-number(R-number)is devised for *** particular,some basic results of the R-number and ren-symmetry are exposed which allow one to derive,in principle,some new types of integrable systems including ren-integrable models and ren-symmetric integrable *** examples of ren-integrable KdV-type systems and ren-symmetric KdV equations are explicitly given.

关键词： symmetries integrable systems anyon physics extended supersymmetry ren-symmetry

Influence of Air Humidity on Transonic Flows with Weak shock Waves

在线全文

学校读者我要写书评

暂无评论

Journal of Thermal science 2020年第6期29卷 1551-1557页

作者： dykas slawomir MAJKUT Miroslaw sMOLKA Krystian Institute of Power Engineering and Turbomachinery Silesian University of TechnologyKonarskiego 18Gliwice 44-100Poland

The paper presents CFD results for the transonic flow of dry and moist air through a diffuser and a compressor *** both test geometries,*** sajben transonic diffuser and the NAsA Rotor 37,the air humidity impact on the structure of flows with weak shock waves was *** CFD simulations were performed by means of an in-house CFD code,which was the RANs-based modelling approach to compressible flow *** is shown that at high values of relative humidity,above 70%,the modelling of the transonic flow field with weak shock waves by means of the dry air model may produce wrong results.

关键词： dry air moist air transonic flow weak shock wave steam condensation

AutoRhythmAI: A Hybrid Machine and Deep Learning Approach for Automated Diagnosis of Arrhythmias

在线全文

学校读者我要写书评

暂无评论

Computers, Materials & Continua 2024年第2期78卷 2137-2158页

作者： s.Jayanthi s.Prasanna Devi Department of Computer science and Engineering SRM Institute of Science and Technology-Vadapalani CampusChennaiTamil NaduIndia

In healthcare,the persistent challenge of arrhythmias,a leading cause of global mortality,has sparked extensive research into the automation of detection using machine learning(ML)***,traditional ML and AutoML approaches have revealed their limitations,notably regarding feature generalization and automation *** glaring research gap has motivated the development of AutoRhythmAI,an innovative solution that integrates both machine and deep learning to revolutionize the diagnosis of *** approach encompasses two distinct pipelines tailored for binary-class and multi-class arrhythmia detection,effectively bridging the gap between data preprocessing and model *** validate our system,we have rigorously tested AutoRhythmAI using a multimodal dataset,surpassing the accuracy achieved using a single dataset and underscoring the robustness of our *** the first pipeline,we employ signal filtering and ML algorithms for preprocessing,followed by data balancing and split for *** second pipeline is dedicated to feature extraction and classification,utilizing deep learning ***,we introduce the‘RRI-convoluted trans-former model’as a novel addition for binary-class *** ensemble-based approach then amalgamates all models,considering their respective weights,resulting in an optimal model *** our study,the VGGRes Model achieved impressive results in multi-class arrhythmia detection,with an accuracy of 97.39%and firm performance in precision(82.13%),recall(31.91%),and F1-score(82.61%).In the binary-class task,the proposed model achieved an outstanding accuracy of 96.60%.These results highlight the effectiveness of our approach in improving arrhythmia detection,with notably high accuracy and well-balanced performance metrics.

关键词： Automated machine learning neural networks deep learning arrhythmias