检索结果-南通市图书馆

Weighted Norm Inequalities of the Maximal Commutator of Quasiradial Bochner-Riesz Operators

在线全文

学校读者我要写书评

暂无评论

Acta Mathematica Sinica,English Series 2013年第9期29卷 1743-1756页

作者： yong Cheol kim Department of Mathematics Education Korea University

In this paper, we obtain certain Lpw（Rn）-mapping properties for the maximal operator associated with the commutators of quasiradial Bochner-Riesz means with index δ under certain surface condition on Σed , provided that δ （n-1）/2, b ∈ BMO（Rn）, 1 p ∞ and w ∈ A1 . Moreover, if δ （n-1）/2, then we prove that the above maximal operator admits weak type （H1w（Rn）, L1w（Rn））-mapping properties for b ∈ BMO（Rn） and w ∈ A1 under the surface condition on Σed .

关键词： Commutator quasiradial Bochner–Riesz operators weighted norm inequalities

Numerical Study on Air Turbines with Enhanced Techniques for OWC Wave Energy Conversion

在线全文

学校读者我要写书评

暂无评论

China Ocean Engineering 2017年第5期31卷 517-527页

作者： CUI Ying HYUN Beom-soo kim Kilwon Department of Ocean Engineering College of EngineeringOcean University of China Division of Naval Architecture and Ocean Engineering Korea Maritime and Ocean University

In recent years,the oscillating water column(OWC) wave energy converter,which can capture wave energy from the ocean,has been widely applied all over the *** the essential part of the OWC system,the impulse and Wells turbines are capable of converting the low pressure pneumatic energy into the mechanical shaft *** an enhanced technique,the design of endplate or ring attached to the blade tip is investigated numerically in this paper.3 D numerical models based on a CFD-software FLUENT 12.0 are established and validated by the corresponding experimental results from the reports of Setoguchi et al.(2004) and Takao et al.(2001).Then the flow fields and non-dimensional evaluating coefficients are calculated and analyzed under steady *** show that the efficiency of impulse turbine with ring can reach up to 0.49 when Ф=1,which is 4% higher than that in the cases for the endplate-type and the original *** the ring-type Wells turbine with fixed guide vanes shows the best performance with the maximal efficiency of 0.55,which is 22% higher than that of the original *** addition,the quasi-steady analysis is used to calculate the mean efficiency and output-work of a wave cycle under sinusoidal flow *** all together,this study provides support for structural optimization of impulse turbine and Wells turbine in the future.

关键词： OWC impulse turbine Wells turbine CFD endplate ring quasi-steady analysis

Connolly Surface on an Atomic Structure via Voronoi Diagram of Atoms

在线全文

同方期刊数据库

学校读者我要写书评

暂无评论

Journal of Computer Science & Technology 2006年第2期21卷 255-260页

作者： Joonghyun Ryu Rhohun Park Deok-soo kim Voronoi Diagram Research Center Hanyang University Seoul Korea Department of Industrial Engineering Hanyang University Seoul Korea

One of the most important geometric structures of a protein is the Connolly surface of protein since a Connolly surface plays an important role in protein folding, docking, interactions between proteins, amongst other things. This paper presents an algorithm for precisely and efficiently computing the Connolly surface of a protein using a proposed geometric construct called β-shape based on the Voronoi diagram of atoms in the protein. Given the Voronoi diagram of atoms based on the Euclidean distance from the atom surfaces, the proposed algorithm first computes a β-shape with an appropriate probe. Then, the Connolly surface is computed by employing the blending operation on the atomic complex of the protein by the given probe.

关键词： protein Connolly/molecular surface β-shape Voronoi diagram of atoms blending surface

Accurate Multi-Scale Feature Fusion CNN for Time Series Classification in Smart Factory

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Computers, Materials & Continua 2020年第10期65卷 543-561页

作者： Xiaorui Shao Chang soo kim Dae Geun kim Department of Information Systems Pukyong National UniversityBusan608737South Korea Korea Dyeing&Finishing Technology Institute Busan608737South Korea

Time series classification(TSC)has attracted various attention in the community of machine learning and data mining and has many successful applications such as fault detection and product identification in the process of building a smart ***,it is still challenging for the efficiency and accuracy of classification due to complexity,multi-dimension of time *** paper presents a new approach for time series classification based on convolutional neural networks(CNN).The proposed method contains three parts:short-time gap feature extraction,multi-scale local feature learning,and global feature *** the process of short-time gap feature extraction,large kernel filters are employed to extract the features within the short-time gap from the raw time ***,a multi-scale feature extraction technique is applied in the process of multi-scale local feature learning to obtain detailed *** global convolution operation with giant stride is to obtain a robust and global feature *** comprehension features used for classifying are a fusion of short time gap feature representations,local multi-scale feature representations,and global feature *** test the efficiency of the proposed method named multi-scale feature fusion convolutional neural networks(MSFFCNN),we designed,trained MSFFCNN on some public sensors,device,and simulated control time series data *** comparative studies indicate our proposed MSFFCNN outperforms other alternatives,and we also provided a detailed analysis of the proposed MSFFCNN.

关键词： Time Series Classifications(TSC) smart factory Convolutional Neural Networks(CNN)

Microstructure and texture evolution of Ti-Nb-Si based alloys for biomedical applications

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Rare Metals 2006年第Z2期25卷 163-167页

作者： kim Won-yong kim Han-Sol Advanced Materials R&D Division Korea Institute of Industrial Technology Incheon 406-130 Korea

Microstructure and texture of Ti-Nb-Si based alloys, prepared by water quenching from β-phase field, cold rolling and recrystallization heat treatment followed by water quenching, were investigated in terms of optical microstructure and analysis of X-ray pole figure result. In as-quenched sample, relatively random distribution of pole figure was detected without showing a specific texture component. In as-cold rolled sample, however, it is found well-developed several texture components consisting of rotated cube, α-fiber and γ-fiber texture components which are frequently observed in bcc-structured metals and alloys were found. Therefore, texture components developed in the present alloys are closely related to the deformation of β-phase even though small amount of α″ phase co-exist in the microstructure. In recrystallized sample, α-fiber texture component is weakly detected while the other texture components, rotated cube and γ-fiber components, appears to be relatively unchanged. No additional texture components were detected besides those texture components observed in the cold rolled samples.

关键词： Ti-Nb-Si based alloys microstructure texture

The Role of Relative Spinal Motion during Feline Galloping for Speed Performance

在线全文

学校读者我要写书评

暂无评论

Journal of Bionic Engineering 2014年第4期11卷 517-528页

作者： Young Kook kim Jongwon Park Byungho Yoon Kyung-soo kim soohyun kim Robotics Program Korea Advanced Institute of Science and Technology (KAIST) Daejeon 305-701 Republic of Korea Department of Mechanical Engineering Korea Advanced Institute of Science and Technology (KAIST) Daejeon 305-701 Republic of Korea

Felines use their spinal column to increase their running speed at rapid locomotion performance. However, its motion profile behavior during fast gait locomotion has little attention. The goal of this study is to examine the relative spinal motion profile during two different galloping gait speeds. To understand this dynamic behavior trend, a dynamic motion of the feline animal （Felis catus domestica） was measured and analyzed by motion capture devices. Based on the experiments at two different galloping gaits, we observed a significant increase in speed （from 3.2 m.s-1 to 4.33 m.s-1） during the relative motion profile synchronization between the spinal （range： 118.86~ to 168.00~） and pelvic segments （range： 46.35~ to 91.13~） during the hindlimb stance phase （time interval： 0.495 s to 0.600 s）. Based on this discovery, the relative angular speed profile was applied to understand the possibility that the role of the relative motion match during high speed locomotion generates bigger ground reaction force.

关键词： feline galloping galloping gait pattern relative spinal motion speed performance phase match

Intelligent structured nanocomposite adhesive for bioelectronics and soft robots

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Nano Research 2024年第2期17卷 534-549页

作者： Yeon soo Lee Min-Seok kim Da Wan kim Changhyun Pang School of Chemical Engineering Sungkyunkwan University(SKKU)Suwon 16419Republic of Korea Mechanical Metrology Group Korea Research Institute of Standards and ScienceDaejeon 34113Republic of Korea Department of Electronic Engineering Korea National University of TransportationChungbuk 27469Republic of Korea Samsung Advanced Institute for Health Sciences and Technology Sungkyunkwan University(SKKU)Suwon 16419Republic of Korea

The remarkable functionality of biological systems in detecting and adapting to various environmental conditions has inspired the design of the latest electronics and robots with advanced *** review focuses on intelligent bio-inspired strategies for developing soft bioelectronics and robotics that can accommodate nanocomposite adhesives and integrate them into biological *** underlying principles of the material and structural design of nanocomposite adhesives were investigated for practical applications with excellent functionalities,such as soft skin-attachable health care sensors,highly stretchable adhesive electrodes,switchable adhesion,and untethered soft *** addition,we have discussed recent progress in the development of effective fabrication methods for micro/nanostructures for integration into devices,presenting the current challenges and prospects.

关键词： biomimetics bio-adhesive switchable adhesion bioelectronics nanocomposite soft robotics

Integration of earth-abundant cocatalysts for high-performance photoelectrochemical energy conversion

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Journal of Energy Chemistry 2024年第1期88卷 336-355,I0008页

作者： Joonhee Ma Sang Hyun Ahn soo Young kim Department of Materials Science and Engineering Korea UniversitySeoul 02841Republic of Korea School of Chemical Engineering and Materials Science Chung-Ang University84 Heukseok-roDongjak-guSeoul 06974Republic of Korea

Photoelectrochemical(PEC)energy conversion has emerged as a promising and efficient approach to sustainable energy harvesting and *** utilizing semiconductor photoelectrodes,PEC devices can harness solar energy and drive electrochemical reactions such as water splitting or carbon dioxide(CO_(2))reduction to generate clean fuels and value-added ***,PEC energy conversion faces several challenges such as high overpotential,sluggish reaction kinetics,charge carrier recombination,and stability issues,which limit its practical ***,significant research has been conducted to improve the overall conversion efficiency of PEC *** particularly promising approach is the use of cocatalysts,which involves introducing specific cocatalysts onto the photoelectrode surface to promote charge separation,improve reaction kinetics,and reduce the overpotential,thereby enhancing the overall performance of PEC energy *** review provides a comprehensive overview of the recent developments in the earth-abundant cocatalysts for PEC water splitting and CO_(2) *** main earth-abundant catalysts for the PEC water splitting include transition-metal dichalcogenide(TMD)-based materials,metal phosphides/carbides,and metal oxides/***,PEC-CO_(2)RR was divided into C_(1) and C_(2+)based on the final product since various products could be produced,focusing on diverse earth-abundant materials-based *** addition,we provide and highlight key advancements achieved in the very recent reports on novel PEC system design engineering with ***,the current problems associated with PEC systems are discussed along with a suggested direction to overcome these obstacles.

关键词： Solar energy Photo-electrochemical Water splitting CO_(2)reduction Cocatalysts

Factors associated with axial length elongation in high myopia in adults

在线全文

学校读者我要写书评

暂无评论

International Journal of Ophthalmology(English edition) 2021年第8期14卷 1231-1236页

作者： Hong Kyu kim Sung soo kim Department of Ophthalmology Dankook University HospitalDankook University College of MedicineCheonan 31116Republic of Korea Yonsei University Graduate School of Medicine Seoul 03722Republic of Korea Department of Ophthalmology Severance HospitalInstitute of Vision ResearchYonsei University College of MedicineSeoul 03722Republic of Korea

AIM:To investigate the association of axial length(AL)and ocular factors on AL ***:A retrospective chart review of patients who underwent two or more AL examinations for more than two *** 4 groups were divided according to initial AL(<24 mm,24-26 mm,26-28 mm,≥28 mm).Initial fundus photograph was used to find risk factors associated AL ***:The mean age of the patients was 47.21±7.79 *** remained almost unchanged in the groups with AL<24 mm and 24≤AL<26 *** the contrary,AL increased by 0.011 mm/y in the group with 26≤AL<28 mm and 0.035 mm/y in the group with AL≥28 mm(P<0.001).In high myopia,AL elongation increased in eye with longer AL(r=0.003,P=0.024),female gender(r=0.014,P=0.019),eye with larger peripapillary chorioretinal atrophic area(r=0.002,P=0.019),and smaller vascular arcade angle(r=-0.004,P=0.006).The risk of elongation 0.03 mm/y in high myopia was increased in female gender(P=0.040),and gradually increased in eye with large peripapillary chorioretinal atrophy area(P<0.01).CONCLUSION:AL elongate significantly in the eye with longer AL,female gender,and the eye with larger atrophic area and smaller arcade angle on fundus photography.

关键词： axial length elongation fundus photography high myopia myopic complication