检索结果-南通市图书馆

Prediction of liquid circulation flow rate in RH degasser:improvement of decarburization at low atmospheric pressure

维普期刊数据库评论

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Journal of Iron and Steel Research International 2024年第7期31卷 1661-1667页

The two-fluid model coupled with population balance model was used for simulating the gas-liquid flow in the Ruhrstahl-Heraeus(RH)*** predicted circulation flow rate was compared with that measured from a water model experiment to validate the mathematical ***,influence of snorkel immersion depth on liquid circulation flow rate was numerically investigated under an atmospheric pressure of 101 and 84 kPa,*** result indicates that the circulation flow rate of the RH degasser in the high-altitude area was severely reduced because of the decrease in atmospheric ***,increasing the snorkel immersion depth from 0.5 to 0.7 m can compensate for the decrease in atmospheric *** test result indicates that decarburization rate is significantly enhanced by increasing the snorkel immersion *** optimization,the percentage of heats with a final carbon content less than 0.002 wt.%is significantly increased from 22.0%to 96.4%.

关键词： RH degasser Two-fluid model Population balance model-Circulation flow rate Decarburization Snorkel immersion depth

Enhanced thermoelectric performance enabled by compositing ZrO_(2)in n-type SiGe alloy with low thermal conductivity

维普期刊数据库评论

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Rare Metals 2024年第3期43卷 1167-1176页

作者： meng-Fei Wang Hua-jun Lai Ji-sheng Liang jun-Liang Chen Wang-Yang Ding Qi Zhou Ying Peng Cheng-Yan Liu Lei Miao Guangxi Key Laboratory for Relativity Astrophysics State Key Laboratory of Featured Metal Materials and Life-Cycle Safety for Composite StructuresSchool of Physical Science and TechnologyGuangxi UniversityNanning530004China Guangxi Academy of Sciences Nanning530007China Key Laboratory of Information Material Engineering Research Center of Electronic Information Materials and DevicesGuilin University of Electronic TechnologyMinistry of EducationGuilin541004China Guangxi Key Laboratory of Precision Navigation Technology and Application School of Information and CommunicationGuilin University of Electronic TechnologyGuilin541004China

SiGe-based thermoelectric(TE)materials have gained increasing interests due to their low maintenance costs,environmental friendliness and long ***,the intrinsically high thermal conductivity of Si-based materials also results in poor TE *** this investigation,a zirconia(ZrO_(2))composite strategy was applied to an n-type SiGe alloy,tremendously elevating its TE *** mechanical alloying and spark plasma sintering(SPS)processes,the ZrO_(2)induced the formation of nanopores in the SiGe matrix via phosphorus ***,such increase in porosity enhanced the phonon scattering and dramatically suppressed lattice thermal conductivity,from 2.83 to 1.59 W·m^(-1)·K^(-1)at 873 ***,reduced phosphorus doping led to an increase in Seebeck coefficients and a relatively minor decrease in electrical conductivity,The power factor didn't deteriorate significantly,either,as its maximum of~3.43 mW·m^(-1-)K^(-2)was achieved at 873 K with(Si_(0.8)Ge_(0.2))_(0.097)P_(0.03)(ZrO_(2))_(0.003).In short,a peak figure of merit(ZT)of~1.27 at 873 K and an average ZT~0.7 from 323 to 873 K were *** study demonstrates that the electrical and thermal transportation of SiGe material can be synergistically tuned by compositing ZrO_(2),illustrating a novel strategy to optimize the TE properties of bulk materials.

关键词： Thermoelectric SiGe alloy ZrO2 composting P element adsorption nanopores

Output Feedback Stabilization of High-Order Nonlinear Time-Delay Systems With Low-Order and High-Order Nonlinearities

在线全文

学校读者我要写书评

暂无评论

IEEE/CAA Journal of Automatica Sinica 2024年第5期11卷 1304-1306页

作者： meng-meng Jiang Kemei Zhang Xue-jun Xie School of Mathematics Science Liaocheng UniversityLiaocheng 252059China School of Mathematics Science Qufu Normal UniversityQufu 273165China Institute of Automation Qufu Normal UniversityQufu 273165China

Dear Editor,to This letter deals with the output feedback stabilization of a class of high-order nonlinear time-delay systems with more general low-order and high-order *** constructing reduced-order observer,based on homogeneous domination theory together with the adding a power integrator method,an output feedback controller is developed guarantee the equilibrium of the closed system globally uniformly asymptotically stable.

关键词： Nonlinear stabilization guarantee

Cohomology groups of a new class of Kadison-Singer algebras

在线全文

学校读者我要写书评

暂无评论

Science China Mathematics 2024年第3期67卷 593-606页

作者： Guangyu An Xing Cheng jun sheng School of Mathematics and Data Science Shaanxi University of Science and TechnologyXi’an 710021China

Let N be a maximal discrete nest on an infinite-dimensional separable Hilbert space H,ξ=∑^(∞)_(n=1)en/2n be a separating vector for the commutant N',E_(ξ)be the projection from H onto the subspace[Cξ]spanned by the vectorξ,and Q be the projection from K=H⊕H⊕H onto the closed subspace{(η,η,η)^(T):η∈H}.Suppose that L is the projection lattice generated by the projections(E_(ξ) 0 0 0 0 0 0 0 0),{(E 0 0 0 0 0 0 0 0):E∈N},(I 0 0 0 I 0 0 0 0) and *** show that L is a Kadison-Singer lattice with the trivial ***,we prove that every n-th bounded cohomology group H~n(AlgL,B(K))with coefficients in B(K)is trivial for n≥1.

关键词： Kadison-Singer algebra Kadison-Singer lattice derivation cohomology group

Effect of La_2O_3/Ce O_2 particle size on high-temperature oxidation resistance of electrodeposited Ni-La_2O_3/Ce O_2 composites

在线全文

学校读者我要写书评

暂无评论

Transactions of Nonferrous Metals Society of China 2014年第11期24卷 3571-3577页

作者：孟君晟吉泽升黑龙江科技大学材料科学与工程学院哈尔滨150022 哈尔滨理工大学材料科学与工程学院哈尔滨150040

Ni-La2O3/CeO2 composite films were prepared by electrodeposition from a nickel sulfate bath containing certain content of micrometer and nanometer La2O3/CeO2 particles. The effect of La2O3 or CeO2 particle size on the oxidation resistance of the electrodeposited Ni-La2O3/CeO2 composites in air at 1000 °C was studied. The results indicate that, compared with the electrodeposited Ni-film, Ni-La2O3/CeO2 composites exhibit a superior oxidation resistance due to the codeposited La2O3 or CeO2 particles blocking the outward diffusion of nickel. Moreover, compared with nanoparticles, La2O3 or CeO2 microparticles have stronger effect because La2O3 or CeO2 microparticles also act as a diffusion barrier layer at the onset of oxidation.

关键词： Ni-based composite electrodeposition high-temperature oxidation La2O3 CeO2 reactive element effect oxidation mechanism

Effect of different fillers on oxidation behavior of low-temperature chromizing coating

在线全文

学校读者我要写书评

暂无评论

Transactions of Nonferrous Metals Society of China 2014年第6期24卷 1785-1790页

作者：孟君晟吉泽升哈尔滨理工大学材料科学与工程学院哈尔滨150040 黑龙江科技大学材料科学与工程学院哈尔滨150022

Three different chromizing coatings were produced on Ni substrate using a conventional pack-cementation method with Al2O3,Al2O3＋CeO2 and CeO2 acting as filler,respectively,at a greatly decreased temperature（700 ℃）.Effects of different fillers on the isothermal and cyclic oxidation resistance of chromizing coating in air at 850 ℃ were comparably *** results show that the addition of CeO2 into the filler significantly retards the grain growth of the chromizing *** results indicate that the chromizing coating using CeO2 as filler exhibits somewhat increased oxidation resistance than the normal chromizmg coating,while the chromizing coating using Al2O3＋CeO2 as filler exhibits much better oxidation *** effects of different fillers on the oxidation behaviors were discussed in detail.

关键词： chromizing coating filler CeO2 oxidation reactive element effect

Effect of Co on oxidation and hot corrosion behavior of two nickel-based superalloys under Na_(2)SO_(4)-NaCl at 900℃

在线全文

学校读者我要写书评

暂无评论

Transactions of Nonferrous Metals Society of China 2021年第8期31卷 2402-2414页

作者： jun-sheng meng Ming-xuan CHEN Xiao-ping SHI Qiang MA Naval Architecture and Port Engineering College Shandong Jiaotong UniversityWeihai 264200China

Nickel-based superalloys with and without Co by partial replacement of W were prepared using double vacuum melting.A comparison of the oxidation in air and hot corrosion behaviors under molten 75 wt.%Na2 SO4+25 wt.%NaCl at 900℃were systematically *** results showed that partial replacement of W with Co promoted the formation of chromia scale and consequently decreased the oxidation ***,the addition of Co also retarded the internal oxidation/nitridation of Al and consequently promoted the growth of Al_(2) O3 scale,which further decreased the scaling rate and improved the adhesion of ***,the addition of Co also further improved the hot corrosion resistance under molten Na2 SO4-NaCl salts.

关键词： nickel based superalloys oxidation hot corrosion spallation resistance

I-DCGAN and TOPSIS-IFP:A simulation generation model for radiographic flaw detection images in light alloy castings and an algorithm for quality evaluation of generated images

在线全文

学校读者我要写书评

暂无评论

China Foundry 2024年第3期21卷 239-247页

作者： Ming-jun Hou Hao Dong Xiao-yuan Ji Wen-bing Zou Xiang-sheng Xia meng Li Ya-jun Yin Bao-hui Li Qiang Chen Jian-xin Zhou State Key Laboratory of Materials Processing and Die&Mould Technology Huazhong University of Science and TechnologyWuhan 430074China Xinjiang Technology(Jiangsu)Co. Ltd.Nantong 226100JiangsuChina Southwest Technique and Engineering Research Institute Chongqing 400039China Shanghai Spaceflight Precision Machinery Institute Shanghai 201600China

The intelligent detection technology driven by X-ray images and deep learning represents the forefront of advanced techniques and development trends in flaw detection and automated evaluation of light alloy ***,the efficacy of deep learning models hinges upon a substantial abundance of flaw *** existing research on X-ray image augmentation for flaw detection suffers from shortcomings such as poor diversity of flaw samples and low reliability of quality *** this end,a novel approach was put forward,which involves the creation of the Interpolation-Deep Convolutional Generative Adversarial Network(I-DCGAN)for flaw detection image generation and a comprehensive evaluation algorithm named TOPSIS-IFP.I-DCGAN enables the generation of high-resolution,diverse simulated images with multiple appearances,achieving an improvement in sample diversity and quality while maintaining a relatively lower computational ***-IFP facilitates multi-dimensional quality evaluation,including aspects such as diversity,authenticity,image distribution difference,and image distortion *** results indicate that the X-ray radiographic images of magnesium and aluminum alloy castings achieve optimal performance when trained up to the 800th and 600th epochs,*** TOPSIS-IFP value reaches 78.7%and 73.8%similarity to the ideal solution,*** to single index evaluation,the TOPSIS-IFP algorithm achieves higher-quality simulated images at the optimal training *** approach successfully mitigates the issue of unreliable quality associated with single index *** image generation and comprehensive quality evaluation method developed in this paper provides a novel approach for image augmentation in flaw recognition,holding significant importance for enhancing the robustness of subsequent flaw recognition networks.

关键词： light alloy casting flaw detection image generator discriminator comprehensive evaluation index

Reducing Operation Emissions and Improving Work Efficiency Using a Pure Electric Wheel Drive Tractor

在线全文

学校读者我要写书评

暂无评论

Engineering 2024年第6期37卷 230-245页

作者： Chang-Kai Wen Wen Ren Qing-Zhen Zhu Chun-Jiang Zhao Zhen-Hao Luo sheng-Li Zhang Bin Xie Zhi-jun meng Research Center of Intelligent Equipment Beijing Academy of Agriculture and Forestry SciencesBeijing 100097China State Key Laboratory of Intelligent Agricultural Power Equipment Beijing 100097China BYD Company Limited Shenzhen 518118China College of Agricultural Engineering Jiangsu UniversityZhenjiang 212013China College of Engineering China Agricultural UniversityBeijing 100083China

In response to the problems of excessive greenhouse-gas and particulate emissions and the low traction efficiency of conventional diesel tractors in the field,a purely electric wheel-side drive tractor was studied,including an electric motor drive system,a battery ballast system,and an electro–hydraulic suspension *** paper develops a dynamics model of an electric tractor-ploughing unit under complex soil conditions,leading to the proposal of an active control method for drive wheel torque and a joint control method for the traction force of the suspension system and the front-and rear-axle loads of a ***,the tractor is prototyped and assembled,and ploughing tests are carried *** ploughing results show that the active torque-distribution control method proposed in this study reduces the tractor slip by 14.83%and increases the traction efficiency by 10.28%compared with the average torquedistribution *** with the conventional traction control mode,the joint control method for traction and ballast proposed in this paper results in a 3.7%increase in traction efficiency,a 15.05%decrease in slip,and a 4.9%reduction in total drive motor energy *** study will help to improve the operation quality and traction efficiency of electric tractors in complex soil conditions.

关键词： Electric tractor Ploughing unit Torque distribution Active ballast Traction performance