检索结果-南通市图书馆

Inflow and outflow permeability tests in a very soft clay under low stresses

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

journal of Rock Mechanics and Geotechnical Engineering 2024年第8期16卷 3270-3283页

作者： j.W.S.Vargas F.A.b.Danziger F.R.Lopes t.Lunne Federal University of Rio de janeiro Rio de JaneiroBrazil Norwegian Geotechnical Institute OsloNorway

In situ inflow and outflow permeability tests with the bAt probe at SarapuíII soft clay test site are presented.A description of the bAt permeability test is provided,discussing its advantages and shortcomings,especially in the case of very soft clays under low *** pressures were monitored during probe installation and were found to be slightly lower than piezocone u2 pore pressures,consistent with the position of the *** role of filter tip saturation was investigated after the usual saturation procedure provided an unsatisfactory pore pressure response during probe *** show that the vacuum saturation procedure provides adequate response during installation and increases the reliability of the coefficient of permeability determination in early *** inflow and outflow tests yielded similar results,indicating that careful execution of the test can lead to good test repeatability regardless of the loading *** sequences of alternated inflow and outflow tests have yielded similar results,indicating that soil reconsolidation and filter clogging were negligible in the tests *** are presented concerning the relationship between index parameters and the in situ coefficient of permeability for SarapuíII clay,which plot outside the range of existing databases.

关键词： Permeability test Soft clay bAt probe Inflow and outflow tests

Generalized time-dependent generator coordinate method for induced fission dynamics

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Frontiers of physics 2024年第4期19卷 1-12页

作者： b.Li D.Vretenar t.Nikšić j.Zhao P.W.Zhao j.Meng State Key Laboratory of Nuclear Physics and technology School of PhysicsPeking UniversityBeijing 100871China Physics Department Faculty of ScienceUniversity of Zagreb10000 ZagrebCroatia Center for Circuits and Systems Peng Cheng LaboratoryShenzhen 518055China

the generalized time-dependent generator coordinate method(tD-GCM)is extended to include pairing *** correlated GCM nuclear wave function is expressed in terms of time-dependent generator states and weight *** particle–hole channel of the effective interaction is determined by a Hamiltonian derived from an energy density functional,while pairing is treated dynamically in the standard bCS approximation with time-dependent pairing tensor and single-particle occupation *** the inclusion of pairing correlations,various time-dependent phenomena in open-shell nuclei can be described more *** model is applied to the description of saddle-to-scission dynamics of induced *** generalized tD-GCM charge yields and total kinetic energy distribution for the fission of 240Pu,are compared to those obtained using the standard time-dependent density functional theory(tD-DFt)approach,and with available data.

关键词： nuclear density functional theory generator coordinate method fission dynamics

Water Vapor Information from Satellite and Its Applications

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Advances in Atmospheric Sciences 2024年第1期41卷 188-189页

作者： b.j.SOHN School of Earth and Environmental Sciences Seoul National UniversitySeoul 08826Korea

Water vapor is a critical component of the hydrological cycle because it plays a vital role in transporting water from one part of the cycle to *** vapor evaporated from surfaces such as oceans,lakes,and rivers conden... 详细信息

关键词： motion oceans lakes

In situ characterization of particle formation in spray flame synthesis using wide-angle light scattering

在线全文

学校读者我要写书评

暂无评论

Particuology 2024年第3期86卷 304-312页

作者： Simon Aβmann Franz j.t.Huber Stefan Will Lehrstuhl für technische thermodynamik(Ltt) Friedrich-Alexander-Universitat Erlangen-Nürnberg(FAU)Erlangen91058Germany Erlangen Graduate Schoolin Advanced Optical technologies(SAOt) Friedrich-Alexander-Universitat Erlangen-Nurnberg(FAU)Erlangen91052Germany Competence Unit Engineering of Advanced Materials(EAM) Friedrich-Alexander-Universitat Erlangen-Nürnberg(FAU)Erlangen91052Germany

Wide-angle light scattering(WALS)was used for in situ measurements of droplet and nanoparticle size distributions during the synthesis of titania and iron oxide particles from liquid precursor solutions in the standardized SpraySyn burner for spray flame *** was synthesized from titanium tetraisopropoxide(ttIP)and iron oxide from iron(II)nitrate nonahydrate(INN)using ethanol(EtOH)as *** images were taken at heights up to 120 mm above the burner surface and classified into droplet and particle *** size distributions were derived from a sequential analysis of scattering data containing the oscillating Mie pattern,the lognormal size distribution parameters for spherical and fractal particle fractions from a multivariate approach on averaged particle scattering *** results show that the precursor addition leads to altered evaporation behavior and even droplet disruption probably induced by puffing or micro-explosions compared to pure *** the case of ttIP(a hygroscopic alkoxide),the synthesis of a large fraction of spheres was observed,while the nitrate INN leads to the formation of mostly fractal aggregates.

关键词： Spray flame synthesis Metal oxide particles Elastic light scattering Droplet size distribution Nanoparticle morphology Particle size distribution

Compressive property and energy absorption characteristic of interconnected porous Mg-Zn-Y alloys with adjusting Y addition

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

journal of Magnesium and Alloys 2024年第1期12卷 171-185页

作者： j.A.Liu S.j.Liu b.Wang W.b.Sun X.j.Liu Z.W.Han College of Materials Science and Engineering Key Laboratory of Automobile Materials(Ministry of Education)Jilin UniversityChangchun 130022PR China Key Laboratory of bionic Engineering(Ministry of Education) College of Biological and Agricultural EngineeringJilin UniversityChangchun130022PR China Weihai Institute for bionics-jilin University Weihai 264205PR China

In this study,interconnected porous Mg-2Zn-xY alloys with different phase compositions were prepared by various Y additions(x=0.4,3,and 6 wt.%)to adjust the compressive properties and energy absorption *** characterization methods were then applied to identify the microstructure of the porous Mg-Zn-Y and describe the details of the second *** tests were performed at room temperature(Rt),200℃,and 300℃to study the impact of the Y addition and testing temperature on the compressive properties of the porous *** experimental results showed that a high Y content promotes a microstructure refinement and increases the volume fraction of the second *** the Y content increases,different Mg-Zn-Y ternary phases appear:I-phase(Mg_(3)Zn_(6)Y),W-phase(Mg_(3)Zn_(3)Y_(2)),and LPSO phase(Mg_(12)ZnY).When the Y content ranges between 0.4%and 6%,the compressive strength increases from 6.30MPa to 9.23 MPa,and the energy absorption capacity increases from 7.33 Mj/m^(3)to 10.97 Mj/m^(3)at Rt,which is mainly attributed to the phase composition and volume fraction of the second ***,the average energy absorption efficiency is independent of the Y *** addition,the compressive deformation behaviors of the porous Mg-Zn-Y are altered by the testing *** compressive strength and energy absorption capacity of the porous Mg-Zn-Y decrease due to the softening effect of the high temperature on the *** deformation behaviors at different temperatures are finally observed to reflect the failure mechanisms of the struts.

关键词： Porous magnesium Rare earth elements Microstructure Compressive behavior Energy absorption characteristic

Reply to the note by Li Piani et al.

在线全文

学校读者我要写书评

暂无评论

Defence technology（防务技术） 2024年第1期31卷 603-606页

作者： t.Li Piani j.Weerheijm L.j.Sluys tU Delft Stevinweg 12628 CNDelftthe Netherlands tNO PO Box 452280 AARijswijkthe Netherlands NLDA Faculty of Military Sciences1781 CADen Helderthe Netherlands

In 2017,a ballistic phenomenological model was proposed by the authors of Ref.[1] to numerically simulate the experimental depths of small caliber projectiles impacting walls made of *** opportunity for a new model in the field revealed from the observation that two older models recently used by the authors of Ref.[2] shared a linear relationship between the penetration depth P and the impacting velocity v_(O).

关键词： Penetration Adobe Modeling

Mathematical modelling of ball and plate system with experimental and correlation function-based model validation

在线全文

学校读者我要写书评

暂无评论

Control theory and technology 2024年第2期22卷 326-341页

作者： t.R.Dil Kumar S.j.Mija Department of Electrical Engineering National Institute of Technology CalicutKozhikode673601KeralaIndia

the ball and plate system is an inherently nonlinear under actuated benchmark system used for validating the performance of various control schemes. A mathematical model depicting the dynamics close to that of the system is very much required for such a test bed. In this correspondence, the complete nonlinear model, a simplified nonlinear model, and a linearized model of the ball and plate system are developed. the system comprises a ball and plate mechanism and a rotary servo unit. the ball and plate mechanism is modelled using the Euler–Lagrange method, whereas the rotary servo subsystem is modelled from the first principles. the nonlinear model of the combined system is developed by including the dynamics of the servo motor with gear and rolling resistance between the ball and the plate. the simplified nonlinear model of the system is obtained with suitable assumptions. the model is linearized around the operating point using the jacobian. the validity of the developed models is investigated through correlation function analysis. the open-loop response of the three models, viz., nonlinear, simplified nonlinear, and linearized models, is analyzed in the MAtLAb/Simulink platform. Since the open-loop system is unstable, the experimental validation of the model is performed with a double-loop PSO (particle swarm optimization) PID control scheme.

关键词： ball and plate system Correlation function Model validation Particle swarm optimization(PSO) PSO PID controller

Iron regulatory protein 1: the deadly switch of ferroptosis

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Neural Regeneration Research 2024年第3期19卷 477-478页

作者： Daniel A.bórquez Pamela j.Urrutia Center for biomedical Research Faculty of MedicineUniversidad Diego PortalesSantiagoChile Institute of Nutrition&Food technology(INtA) Universidad de ChileSantiagoChile Geroscience Center for brain Health and Metabolism SantiagoChile

Ferroptosis,an iron-dependent cell death:Ferroptosis is a type of regulated necrosis,characterized by redox-active iron accumulation and increased free radical production derived by Fenton chemistry,that triggers oxidation of polyunsaturated fatty acids in phospholipids,loss of cellular membranes integrity,and leakage of intracellular contents.

关键词： integrity switch Iron

thermo-kinetic characteristics on stabilizing hetero-phase interface of metal matrix composites by crystal plasticity finite element method

在线全文

学校读者我要写书评

暂无评论

journal of Materials Science & technology 2024年第2期169卷 53-67页

作者： Y.b.Zhang S.j.Song F.Liu State Key Laboratory of Solidification Processing Northwestern Polytechnical UniversityXi’an 710072China Analytical&testing Center Northwestern Polytechnical UniversityXi’an 710072China

Using dislocation-based constitutive modeling in three-dimension crystal plasticity finite element(3D CPFE)simulations,co-deformation and instability of hetero-phase interface in different material systems were herein studied for polycrystalline metal matrix composites(MMCs).Local stress and strain fields in two types of 3layer MMCs such as fcc/fcc Cu-Ag and fcc/bcc Cu-Nb have been predicted under simple compressive ***,more severe strain-induced interface instability can be observed in the fcc/bcc systems than in the fcc/fcc systems upon refining to metallic nanolayered composites(MNCs).by detailed analysis of stress and strain localization,it has been demonstrated that the interface instability is always accompanied by high-stress concentration,i.e.,thermodynamic characteristics,or high strain prevention i.e.,kinetic characteristics,at the hetero-phase *** then follows that the thermodynamic driving forceG and the kinetic energy barrier Q during dislocation and shear banding can be adopted to classify the deformation modes,following the so-called thermo-kinetic *** by inserting a high density of high-energy interfaces into the Cu-Nb composites,such thermo-kinetic integration at the hetero-phase interface allows a successful establishment of MMCs with the high△G-high Q deformation mode,which ensures high hardening and uniform strain distri-bution,thus efficiently suppressing the shear band,stabilizing the hetero-phase interface,and obtaining an exceptional combination in strength and *** hetero-phase interface chosen by a couple of thermodynamics and kinetics can be defined as breaking the thermo-kinetic correlation and has been proposed for artificially designing MNCs.

关键词： thermodynamics and kinetics Physics-based constitutive modeling Hetero-phase interface Crystal plasticity finite element