检索结果-南通市图书馆

Heat and mass transfer of a circular porous moist object located in a triangular shaped vented cavity

在线全文

学校读者我要写书评

暂无评论

Journal of central South University 2024年第6期31卷 1956-1972页

作者： SELIMEfENDIgIL fatih OZcAN cOBAN Seda OZTOP Hakan f Department of Mechanical Engineering College of EngineeringKing Faisal UniversityAl Ahsa 31982Saudi Arabia Department of Mechanical Engineering Manisa Celal Bayar UniversityManisa 45140Turkey Department of Mechanical Engineering Technology FacultyFırat UniversityElazığTurkey

Heat and mass transfer of a circular-shaped porous moist object inside a two-dimensional triangle cavity is investigated by using finite element *** porous object is considered to be a moist food sample,located in the middle of the cavity with inlet and outlet ports with different configurations of inlet/outlet *** drying performance is numerically assessed for different values of Reynolds numbers(between 50 and 250),dry air inlet temperature(between 40 and 80℃)and different locations of the *** is observed that changing the port locations has significant impacts on the flow recirculaitons inside the triangular chamber while convective drying performance is highly *** moisture content reduces with longer time and for higher Reynolds number(Re)*** P4 where inlet and outlet ports are in the middle of the walls provides the most effective configuration in terms of convective drying performance while the worst case is seen for P1 case where inlet and outlet are closer to the corners of the *** is a 192% difference between the moisture reduction of these two cases at Re=250,T=80℃ and t=120 min.

关键词： convective drying porous domain cavity flow inlet/exit port finite element method

Inflow and outflow permeability tests in a very soft clay under low stresses

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Journal of Rock Mechanics and geotechnical Engineering 2024年第8期16卷 3270-3283页

作者： J.W.S.Vargas f.A.B.Danziger f.R.Lopes T.Lunne federal University of Rio de Janeiro Rio de JaneiroBrazil Norwegian geotechnical Institute OsloNorway

In situ inflow and outflow permeability tests with the BAT probe at SarapuíII soft clay test site are presented.A description of the BAT permeability test is provided,discussing its advantages and shortcomings,especially in the case of very soft clays under low *** pressures were monitored during probe installation and were found to be slightly lower than piezocone u2 pore pressures,consistent with the position of the *** role of filter tip saturation was investigated after the usual saturation procedure provided an unsatisfactory pore pressure response during probe *** show that the vacuum saturation procedure provides adequate response during installation and increases the reliability of the coefficient of permeability determination in early *** inflow and outflow tests yielded similar results,indicating that careful execution of the test can lead to good test repeatability regardless of the loading *** sequences of alternated inflow and outflow tests have yielded similar results,indicating that soil reconsolidation and filter clogging were negligible in the tests *** are presented concerning the relationship between index parameters and the in situ coefficient of permeability for SarapuíII clay,which plot outside the range of existing databases.

关键词： Permeability test Soft clay BAT probe Inflow and outflow tests

Nanozyme catalysis in a crowded environment:The impact of diffusion and surface shielding

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Nano Research 2024年第7期17卷 5795-5800页

作者： Vasily g.Panferov Juewen Liu Department of chemistry Waterloo Institute for NanotechnologyWaterlooOntario N2L 3G1Canada

Nanozymes are widely used in various applications as nanosized catalysts for replacing *** accurate estimation of the catalytic activity of nanozymes in real conditions is *** this article,for the first time,we systematically studied the effect of macromolecular molecules co-existing in the real system on the oxidoreductase(peroxidase,oxidase,and catalase)-mimicking nanozymes made of a gold nanoparticle core and a platinum shell,Prussian Blue,Mn_(2)O_(3) and coO *** were made with horseradish *** distinguished two main mechanisms of the negative impact of macromolecules on nanozyme catalysis—slowed diffusion and surface shielding of *** the first mechanism is typical for enzymes,the second one is specific only for *** the mechanisms is essential for developing approaches to reduce the unavoidable impact of macromolecules for various analytical and biomedical applications.

关键词： molecular crowding biosensors nanoparticles

Assessing the biennial conference on science and technology(BIcOST IX)2023 technical output on renewable energy,energy storage,and green hydrogen in line with UN SDg commitments

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

clean Energy 2024年第2期8卷 85-88页

作者： S.K.B.D.Silva K.g.D.Piyumali Rasitha Thilini Suranjana Perera K.D.K.g.Kaluarachchi Thilini Munagamage R.M.R.Ahammed c.S.P.Piyankarage Seyed Shahmy Veranja Karunaratne National Science and Technology commission of Sri Lanka ColomboSri Lanka Sri Lanka Technological campus(SLTc) PadukkaSri Lanka University of Peradeniya PeradeniyaSri Lanka

The development,production and utilization of renewable energy,energy storage and green hydrogen and the associated technologies in Sri Lanka have great potential to contribute to the United Nations’Sustainable Development goals(SDgs).The island aims to achieve 70%electricity generation from renewable energy sources by 2030(within the target of 40%utilization of renewable energy sources for the entire energy generation of the country by 2030).The power sector has to invest US$11 billion from 2023 to 2030 to contribute to reaching this *** commentary aims to provide a critical perspective on the recommendations of the report from the National Science and Technology commission’s 9th biennial conference in 2023 on science and technology,the sub-thematic technical report on clean energy,energy storage and green hydrogen in line with the SDgs in the Sri Lankan *** technical report provides insightful recommendations for Sri Lanka’s energy sector under three main sections:renewable energy,energy storage and green ***,it explores the potential of various renewable energy sources,energy storage systems and green hydrogen as sustainable solutions to address the country’s energy challenges while emphasizing the spillover effects of them,which could contribute to the enterprise’s job creation and uplift the economy.

关键词： renewable energy energy storage green hydrogen sustainable development goals Sri Lanka social economic environmental sustainable affordable

Analysis of the discrete contact characteristics based on the greenwood-Williamson model and the localization principle

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

friction 2024年第5期12卷 1042-1056页

作者： Anastasiya A.YAKOVENKO Irina g.gORYAcHEVA Ishlinsky Institute for Problems in Mechanics RAS Moscow119526Russia

The contact of a rigid body with nominally flat rough surface and an elastic half-space is *** solve the contact problem,the greenwood-Williamson statistical model and the localization principle are *** developed contact model allows us to investigate the surface approach and the real contact area with taking into account the asperities *** is shown that the mutual influence of asperities changes not only contact characteristics at the macroscale,but also the contact pressure distribution at the *** follows from the results,the inclusion in the contact model of the effect of the mutual influence of asperities is especially significant for studying the real contact area,as well as the contact characteristics at high applied *** results calculated according to the proposed approach are in a good agreement with the experimentally observed effects,i.e.,the real contact area saturation and the additional compliance exhaustion.

关键词： surface roughness elasticity greenwood-Williamson model localization principle asperity interaction

control system design for a pressure-tube-type supercritical water-cooled nuclear reactor via a higher order sliding mode method

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Nuclear Science and Techniques 2024年第1期35卷 145-154页

作者： M.Hajipour g.R.Ansarifar Department of Nuclear Engineering Faculty of PhysicsUniversity of IsfahanIsfahan 81746-73441Iran

Nuclear power plants exhibit non-linear and time-variable ***,designing a control system that sets the reactor power and forces it to follow the desired load is complicated.A supercritical water reactor(ScWR)is a fourth-generation conceptual *** an ScWR,the non-linear dynamics of the reactor require a controller capable of control-ling the *** this study,a pressure-tube-type ScWR was controlled during reactor power maneuvering with a higher order sliding mode,and the reactor outgoing steam temperature and pressure were controlled *** an ScWR,the temperature,pressure,and power must be maintained at a setpoint(desired value)during power *** point kinetics equations with three groups of delayed neutrons were used in the ***-order and classic sliding mode controllers were separately manufactured to control the plant and were compared with the PI controllers speci-fied in previous *** controlled parameters were reactor power,steam temperature,and ***,for these parameters,the PI controller had certain instabilities in the presence of *** classic sliding mode controller had a higher accuracy and stability;however its main drawback was the chattering *** was highly accurate and stable and had a small computational *** reality,it followed the desired values without oscillations and chattering.

关键词： Supercritical water nuclear reactor Higher order sliding mode controller Steam temperature Steam pressure Point kinetics model

Numerical simulation of three dimensional concrete printing based on a unified fluid and solid mechanics formulation

在线全文

学校读者我要写书评

暂无评论

frontiers of Structural and civil Engineering 2024年第4期18卷 491-515页

作者： Janis REINOLD Koussay DAADOUcH günther MEScHKE Institute for Structural Mechanics Ruhr University BochumBochum 44801Germany

Deformation control constitutes one of the main technological challenges in three dimensional(3D)concrete printing,and it presents a challenge that must be addressed to achieve a precise and reliable construction ***-based information of the expected deformations and stresses is required to optimize the construction process in association with the specific properties of the concrete *** this work,a novel thermodynamically consistent finite strain constitutive model for fresh and early-age 3D-printable concrete is *** model is then used to simulate the 3D concrete printing process to assess layer shapes,deformations,forces acting on substrate layers and prognoses of possible structural collapse during the layer-by-layer *** constitutive formulation is based on a multiplicative split of the deformation gradient into elastic,aging and viscoplastic parts,in combination with a hyperelastic potential and considering evolving material properties to account for structural buildup or *** advantage of this model is the stress-update-scheme,which is similar to that of small strain plasticity and therefore enables an efficient integration with existing material *** constitutive model uses the particle finite element method,which serves as the simulation framework,allowing for modeling of the evolving free surfaces during the extrusion *** analyses of three printed layers are used to create deformation plots,which can then be used to control the deformations during 3D concrete *** study offers further investigations,on the structural level,focusing on the potential structural collapse of a 3D printed concrete *** capability of the proposed model to simulate 3D concrete printing processes across the scales—from a few printed layers to the scale of the whole printed structure—in a unified fashion with one constitutive formulation,is demonstrated.

关键词： particle finite element method 3D concrete printing multiplicative split additive manufacturing elastoviscoplasticity

Unveiling the early universe:Axion-like particles and their role in primordial structure formation

在线全文

维普期刊数据库

学校读者我要写书评

暂无评论

Science china(Physics,Mechanics & Astronomy) 2024年第11期67卷 178-179页

作者： Sergey g.Rubin National Research Nuclear University MEPhI(Moscow Engineering Physics Institute) Moscow 115409Russia

The groundbreaking discovery of gravitational waves(gWs)by the LIgO-VIRgO-KAgRO collaboration has revolutionized our understanding of the universe and opened up a new way of observing cosmic events. Unlike light waves... 详细信息

关键词： universe gravitational cosmic

Summary of a Life in Observational Ultraviolet/Optical Astronomy

在线全文

学校读者我要写书评

暂无评论

Research in Astronomy and Astrophysics 2024年第1期24卷 1-43页

作者： Donald g.York Department of Astronomy and Astrophysics The University of Chicago5801 South Ellis Ave.Chicago 60637ILUSA

I reminisce on my early life in Section 1;on my education in Sections 2 and 3;on the years at Princeton as a research astronomer in Section 4;on the years on the faculty at chicago in Section 5;on research on Diffuse Interstellar Bands(DIBs) in Section 6;on construction of the 3.5 m telescope at Apache Point Observatory(APO)in Section 7;on work on the Sloan Digital Sky Survey(SDSS) in Section 8;on work in public education in chicago in Section 9;and on my travels in Section 10. My main science research is of an observational nature,concerning galactic and intergalactic interstellar gas. Highlights for me included my work on the orbiting telescope copernicus, including the discovery of interstellar deuterium;early observations of absorption associated with fivetimes ionized oxygen;and discoveries concerning the phases of gas in the local interstellar medium, based on previously unobservable interstellar UV spectral lines. With other instruments and collaborations, I extended interstellar UV studies to the intergalactic cool gas using quasi-stellar object QSO absorption lines redshifted to the optical part of the spectrum;provided a better definition of the emission and morphological character of the source of absorption lines in QSO spectra;and pursued the identification of the unidentified DIBs. for several of these topics, extensive collaborations with many scientists were essential over many years. The conclusions developed slowly, as I moved from being a graduate student at chicago, to a research scientist position at Princeton and then to a faculty position at chicago. At each stage of life, I was exposed to new technologies adaptable to my science and to subsequent projects. from high school days, I encountered several management opportunities which were formative. I have been extremely fortunate both in scientific mentors I had and in experimental opportunities I encountered.

关键词： Interstellar Medium(ISM) Nebulae (galaxies:)quasars:absorption lines ultraviolet:stars