检索结果-南通市图书馆

Effect of rock mass structure and block size on the slope stability——Physical modeling and discrete element simulation

在线全文

学校读者我要写书评

暂无评论

Science china(Technological Sciences) 2005年第z1期48卷 1-17页

作者： LI Shihai1, LIAN Zhenzhong1,2.& J. G. Wang3.1. institute of mechanics, Chinese {2. of Sciences, beijing 100080, china 2. Graduate School, Chinese {2. of Sciences, beijing 100060, china 3. Tropical Marine Science institute, National University of Singapore, Singapore 1192.0 institute of mechanics Chinese Academy of Sciences Beijing 100080 China Graduate School Chinese Academy of Sciences Beijing 100060 China Tropical Marine Science institute National University of Singapore Singapore 119260 Singapore

This paper studies the stability of jointed rock slopes by using our improved three-dimensional discrete element methods (DEM) and physical modeling. Results show that the DEM can simulate all failure modes of rock slopes with different joint configurations. The stress in each rock block is not homogeneous and blocks rotate in failure development. Failure modes depend on the configuration of joints. Toppling failure is observed for the slope with straight joints and sliding failure is observed for the slope with staged joints. The DEM results are also compared with those of limit equilibrium method (LEM). Without considering the joints in rock masses, the LEM predicts much higher factor of safety than physical modeling and DEM. The failure mode and factor of safety predicted by the DEM are in good agreement with laboratory tests for any jointed rock slope.

关键词： rock masses, slope stability, DEM simulation, block size effect, joints configuration effect, limit equilibrium method.

Compression behavior of Zr_(41)Ti_(14)Cu_(12.5)Ni_(10)Be_(2..5) bulk metallic glass up to 2. GPa

在线全文

学校读者我要写书评

暂无评论

Science china(Physics,mechanics & Astronomy) 2005年第3期48卷 319-324页

作者： LI Gong 1, 2., ZHAN Zaiji 2., LIU Jing 3., YUN Jinku 1 , SUN Liling 2., LIU Riping 1 , ZHANG Jun 2.& WANG Wenkui 1, 2.1. Key Laboratory of Metastable Materials Science and Technology, Yanshan University, Qinhuangdao 066004, china 2. Center for Condensed Matter Physics, institute of Physics, Chinese {2. of Sciences, beijing 100080, china 3. BSRF, institute of High Energy Physics, Chinese {2. of Sciences, {13. 10003., china Key Laboratory of Metastable Materials Science and Technology Yanshan University Qinhuangdao China Center for Condensed Matter Physics Institute of Physics Chinese Academy of Sciences Beijing China BSRF Institute of High Energy Physics Chinese Academy of Sciences Beijing China

The compression of a Zr41Ti14Cu12.5Ni10Be2..5 bulk metallic glass (BMG) is investigated at room temperature up to 2. GPa using in-situ high pressure energy dispersive X-ray diffraction with a synchrotron radiation source. The pressure-induced structural relaxation is exhibited. It is found that below about 8 GPa, the existence of excess free volume contributes to the rapid structural relaxation, which gives rise to the rapid volumetric change, and the structural relaxation results in the structural stiffness under higher pressure.

关键词： bulk metallic glass, high pressure, structural relaxation, synchrotron radiation.

Modeling of elastic wave propagation on a curved free surface using an improved finite-difference algorithm

在线全文

学校读者我要写书评

暂无评论

Science china(Physics,mechanics & Astronomy) 2004年第5期47卷 633-648页

作者： WANG Xiuming1,3.& ZHANG Hailan2.1. CSIRO Petroleum, ARRC, PO BOX 113., Technology Park, Bentley, WA 6102. Australia 2. {3. of Acoustics, Chinese academy of Sciences,{2., china 3. Present address: {3. of Acoustics, Chinese academy of Sciences,{2., china CSIRO Petroleum ARRC Bentley Australia institute of Acoustics Chinese Academy of Sciences Beijing China

Based on existing direct and imaging methods of a staggered finite-difference scheme, an improved algorithm for staggered finite-difference is proposed to implement rugged topographic free boundary conditions. This method assumes that the free surface can be implemented with horizontal and vertical free surface segments and their corners; the free surface passes through the grid points of shear stress components, instead of the normal stress components. Imaging is carried out for stress components in both horizontal and vertical directions, thus increasing the accuracy. To update particle- velocities, imaging and updating are first performed in the horizontal direction, and then in the vertical direction. The numerical results for elastic flat horizontal free surface with the imaging method and those for flat free surfaces of various slope angles with the proposed method are compared, and are shown to be in good agreement. The advantage of the proposed method is that only the stresses are dealt with in implementing the free surface into the staggered algorithm, which improves computation efficiency.

关键词： elastic wave simulation, curved free surface, staggered finite-difference, algorithm stability.

Characterization of plastic flow in two Zr-based bulk metallic glasses

在线全文

学校读者我要写书评

暂无评论

Science china(Technological Sciences) 2006年第4期49卷 414-424页

作者： XING Dongmei1,2. ZHANG Taihua1, LI Weihuo3.& WEI Bingchen3.1. State Key Laboratory of Nonlinear mechanics (LNM), institute of mechanics, Chinese academy of Sci- ences, beijing 100080, china 2. College of Physics and Electronic Information Science, Tianjin Normal University, Tianjin 3.0074, china 3. National Microgravity Laboratory, institute of mechanics, Chinese academy of Sciences, beijing 100080, china State Key Laboratory of Nonlinear mechanics (LNM) Institute of Mechanics Chinese Academy of Sciences Beijing 100080 China sychology.lu.se

Plastic deformation behaviors of Zr65Al10Ni10Cu15 and Zr52.5Al10Ni10Cu15Be12.5 bulk metallic glasses (BMGs) are studied by using the depth-sensing nanoindentation, microindentation and uniaxial compression. The Be-containing BMG exhibits a signifi- cantly improved overall plastic strain compared with the Be-free alloy during compressive tests. Both BMGs show a loading-rate-dependent serrated flow during nanoindentation measurements, but the Be-containing alloy exhibits a much lower critical loading rate for the disappearance of the serration than the Be-free BMG. The shear band patterns de- veloped during plastic deformation are investigated by microindentation technique, wherein much higher shear band density is found in the Be-containing alloy than in the Be-free alloy, indicating an easier nucleation of shear bands in the former BMG. The dif- ference in the plastic deformation behavior of the two BMGs can be explained by a free volume model.

关键词： Bulk metallic glass, plastic deformation, shear band, nanoindentation.

A mixed method for measuring low-frequency acoustic properties of macromolecular materials

在线全文

学校读者我要写书评

暂无评论

Science china(Physics,mechanics & Astronomy) 2006年第6期49卷 729-739页

作者： LIU Hongwei1,YAO Lei1,3.ZHAO Hong1,3.ZHANG Jichuan2.3.& XUE Zhaohong2.1. National Key Laboratory of Acoustics,institute of Acoustics,Chinese {3. of Sciences,{2. 100080,china 2. institute of Chemistry,Chinese {3. of Sciences,{2. 100080,china 3. Graduate University of Chinese {3. of Sciences,{2. 100049,china National Key Laboratory of Acoustics Institute of Acoustics Chinese Academy of Sciences Beijing China Graduate University of Chinese academy of Sciences Beijing China institute of Chemistry Chinese Academy of Sciences Beijing China

A mixed method for measuring low-frequency acoustic properties of macro-molecular materials is presented. The dynamic mechanical parameters of materials are first measured by using Dynamic Mechanical Thermal Apparatus(DMTA) at low frequen-cies,usually less than 100 Hz; then based on the Principles of Time-Temperature Super-position (TTS),these parameters are extended to the frequency range that acousticians are concerned about,usually from hundreds to thousands of hertz; finally the extended dynamic mechanical parameters are transformed into acoustic parameters with the help of acoustic measurement and inverse analysis. To test the feasibility and accuracy,we measure a kind of rubber sample in DMTA and acquire the basic acoustic parameters of the sample by using this method. While applying the basic parameters to calculating characteristics of the sample in acoustic pipe,a reasonable agreement of sound absorp-tion coefficients is obtained between the calculations and measurements in the acoustic pipe.

关键词： low-frequency acoustic properties,dynamic mechanical properties,Principles of Time-Temperature Superposition,acoustic pipe,sound absorption coefficient.

A new DNA algorithm to solve graph coloring problem

在线全文

学校读者我要写书评

暂无评论

Progress in Natural Science:Materials International 2007年第6期17卷 733-738页

作者： Jiang Xingpeng1, Li Yin2. Meng Ya3.and Meng Dazhi2.1. National Laboratory of Pattern Recognition,institute of Automation, Chinese {3. of Sciences,{2., china 2. College of Applied Sciences, beijing University of Technology, beijing 10002., china 3. School of Science, beijing institute of Technology, beijing 100081, china) National Laboratory of Pattern Recognition Institute of Automation Chinese Academy of Sciences Beijing 100080 China National High Magnetic Field Laboratory Florida State University 1800 East Paul Dirac Drive Tallahassee Florida 32306 USA

Using a small quantity of DNA molecules and little experimental time to solve complex problems successfully is a goal of DNA computing. Some NP-hard problems have been solved by DNA computing with lower time complexity than conventional computing. However, this advantage often brings higher space complexity and needs a large number of DNA encoding molecules. One example is graph coloring problem. Current DNA algorithms need exponentially increasing DNA encoding strands with the growing of problem size. Here we propose a new DNA algorithm of graph coloring problem based on the proof of four-color theorem. This algorithm has good properties of needing a relatively small number of operations in polynomial time and needing a small number of DNA encoding molecules (we need only 6R DNA encoding molecules if the number of regions in a graph is R).

关键词： DNA computing NP-hard problem graph coloring problem.

Gasdynamic characteristics of toroidal shock and detonation wave converging

在线全文

同方期刊数据库

学校读者我要写书评

暂无评论

Science china(Physics,mechanics & Astronomy) 2005年第6期48卷 739-749页

作者： TENG Honghui1,2.& JIANG Zonglin2.1. Key Laboratory of High Temperature Gas Dynamics, institute of {3., Chinese {2. of Sci- ences, beijing 100080, china 2. Graduate University of Chinese {2. of Sciences, beijing 10003., china Key Laboratory of High Temperature Gas Dynamics Institute of Mechanics Chinese Academy of Sciences Beijing China Graduate University of Chinese academy of Sciences Beijing China

The modified CCW relation is applied to analyzing the shock, detonation wave converging and the role of chemical reactions in the process. Results indicate that the shock wave is strengthened faster than the detonation wave in the converging at the same initial Mach number. Euler equations implemented with a detailed chemical reaction model are solved to simulate toroidal shock and detonation wave converging. Gasdynamic characteristics of the converging are investigated, including wave interaction patterns, observable discrepancies and physical phenomena behind them. By comparing wave diffractions, converging processes and pressure evolutions in the focusing area, the different effects of chemical reactions on diffracting and converging processes are discussed and the analytic conclusion is demonstrated through the observation of numerical simulations.

关键词： converging, CCW relation, shock wave, detonation wave.

Discovery of immune related factors in Fenneropenaeus chinensis by annotation of ESTs

在线全文

学校读者我要写书评

暂无评论

Progress in Natural Science:Materials International 2004年第1期14卷 48-55页

作者： SHEN Yaoqing 1,2. , XIANG Jianhai 1*, WANG Bing 1,2. , LI Fuhua 1 and TONG Wei 3.1. Experimental Marine Biology Laboratory, institute of Oceanology, Chinese {3. of Sciences, Qingdao 2.6071,{2. 2. Graduate School of the Chinese {3. of Sciences, beijing 10003., china 3. Genomics & Bioinformatics institute, Chinese {3. of Sciences, beijing 1013.0, china) Experimental Marine Biology Laboratory Institute of Oceanology Chinese Academy of Sciences Qingdao 266071 China. Graduate School of the Chinese academy of Sciences Beijing 100039 China. Genomics & Bioinformatics institute Chinese Academy of Sciences Beijing 101300 China

A total of 10446 expressed sequence tags (ESTs) are obtained by a large scale sequencing of a cDNA library from cephalothorax of adult Fenneropenaeus chinensis . An EST analysis platform was built up based on local computers and bioinformatic techniques were used to annotate these ESTs in order to promptly find possible functional genes, especially for immune related factors. About 4% of the ESTs show similarity to the coding sequences of such factors, including lectin, serine protease, serpin, lysozyme, etc. These ESTs provide a partial profile of the immune system in F. chinensis and useful information for further study on these genes.

关键词： Fenneropenaeus chinensis bioinformatics ESTs immune factors

Modeling and verifying Web services driven by requirements:An ontology-based approach

在线全文

同方期刊数据库

学校读者我要写书评

暂无评论

Science in china(Series F) 2006年第6期49卷 792-820页

作者： HOU Lishan1,3.JIN ZHi1,2.& WU Budan1,4 1. academy of Mathematics and Systems Science, Chinese academy of Sciences,{2., china 2. institute of Computing Technology, Chinese academy of Sciences,{2., china 3. institute of Software, Chinese academy of Sciences,{2., china 4. Graduate University of Chinese academy of Sciences, beijing 100049, china academy of Mathematics and Systems Science Chinese Academy of Sciences institute of Computing Technology Chinese Academy of Sciences institute of Software Chinese Academy of Sciences Graduate University of Chinese academy of Sciences

Automatic discovery and composition of Web services is an important research area in Web service technology, in which the specification of Web services is a key issue. This paper presents a Web service capability description framework based on the environment ontology. This framework depicts Web services capability in two aspects： the operable environment and the environment changes resulting from behaviors of the Web service. On the basis of the framework, a requirement-driven Web service composition model has been constructed. This paper brings forward the formalization of Web service interactions with π calculus. And an automatic mechanism converting conceptual capability description to the formal process expression has been built. This kind of formal specification assists in verifying whether the composite Web service model matches the requirement.

关键词： Web service environment ontology automatic composition π calculus formal verification.