检索结果-南通市图书馆

Science China(Technological sciences) 2005年第z1期48卷 1-17页

作者： LI Shihai1, LIAN Zhenzhong1,2.& J. G. Wang3.1. Institute of Mechanics, chinese academy of sciences, Beijing 100080, China 2. graduate school, chinese academy of sciences, Beijing 100060, China 3. Tropical Marine Science Institute, National University of Singapore, Singapore 1192.0 chinese Acad Sci Inst Mech Beijing 100080 Peoples R China chinese Acad Sci Grad Sch Beijing 100060 Peoples R China Natl Univ Singapore Trop Marine Sci Inst Singapore 119260 Singapore

This paper studies the stability of jointed rock slopes by using our improved three-dimensional discrete element methods (DEM) and physical modeling. Results show that the DEM can simulate all failure modes of rock slopes with different joint configurations. The stress in each rock block is not homogeneous and blocks rotate in failure development. Failure modes depend on the configuration of joints. Toppling failure is observed for the slope with straight joints and sliding failure is observed for the slope with staged joints. The DEM results are also compared with those of limit equilibrium method (LEM). Without considering the joints in rock masses, the LEM predicts much higher factor of safety than physical modeling and DEM. The failure mode and factor of safety predicted by the DEM are in good agreement with laboratory tests for any jointed rock slope.

关键词： rock masses, slope stability, DEM simulation, block size effect, joints configuration effect, limit equilibrium method.

Experimental investigation and numerical simulation on the effect of fissure water pressure in vertical sliding surface

在线全文

学校读者我要写书评

暂无评论

Science China(Technological sciences) 2005年第z1期48卷 53-64页

作者： ZHANG Lei1,2. LI Shihai1, LIAN Zhenzhong1,2.& WANG Yuannian1 1. Institute of Mechanics, chinese academy of sciences, Beijing 100080, China {3., chinese academy of sciences, Beijing 100060, China 1. Institute of Mechanics Chinese Academy of Sciences 100080 Beijing China 2. graduate school Chinese Academy of Sciences 100060 Beijing China

This paper studies the effect of fissure water pressure in different fractures on the critical angle of landslide by laboratory investigation and numerical simulation in order to understand the mechanisms of fissure water pressure on landslide stability. Laboratory observations show that the effect of fissure water pressure on the critical angle of landslide is little when the distance between water-holding fracture and slope toe is three times greater than the depth of fissure water. These experimental results are also simulated by a three-dimensional face-to-face contact discrete element method. This method has included the fissure water pressure and can accurately calculate the critical angle of jointed slope when fissure water pressure in vertical sliding surface exists. Numerical results are in good agreement with experimental observations. It is revealed that the location of water-holding structural surface is important to landslide stability. The ratio of the distance between water-holding fissure and slope toe to the depth of fissure water is a key parameter to justify the effect of fissure water pressure on the critical angle of landslide.

关键词： jointed rock slope, discrete element method, fracture in vertical sliding surface, model experiment,fissure water pressure.

Experimental and discrete element numerical analysis of side slope instability induced by fissure water underlying impervious bed

在线全文

学校读者我要写书评

暂无评论

Science China(Technological sciences) 2005年第z1期48卷 65-80页

作者： LIU Bingshan1, LI Shihai1, ZHANG Lei1,2.& WANG Jianguo3.. Institute of Mechanics, chinese academy of sciences, Beijing 100080, China 2. graduate school, chinese academy of sciences, Beijing 100060, China 3. Tropical Marine Science Institute, National University of Singapore, 10 Kent Ridge Crescent, Singapore 1192.0 chinese Acad Sci Inst Mech Beijing 100080 Peoples R China chinese Acad Sci Grad Sch Beijing 100060 Peoples R China Natl Univ Singapore Trop Marine Sci Inst Singapore 119260 Singapore

When the sliding mass contains impervious bed, rainfall can infiltrate into mountain via crevices and form higher artesian aquifer at impervious bed inferior. This will decrease slip resistance and increase sliding forces of the sliding mass, thus lowering the safety factor, and inducing landslide disasters. In this paper, a landslide experimental apparatus is designed for experimental studies on the mechanism of this type of landslides. Meanwhile, the non-dimensional parameters in the model experiment are taken into account using dimensional analysis. The experimental results show that (1) the ratio of the cleft water pressure to the overlying pressure is a crucial parameter affecting the stability of the slope; (2. when the shut-in pressure reaches 80% of the normal component of the pressure on the slip surface made up of rock and soil, landslide will occur; (3. the whole slope will start to slide when the shut-in pressure is equal to the normal component of the pressure formed by the overlying rock and soil on the upper 3.% area. In this article, a discrete element method simulation is used to investigate the influence of cleft water pressure and shearing strength on the landslide stability. It can be concluded that the critical value of Ccr, ?cr, which determines the slide mass stability, increases with the increase of the water pressure; if the water pressure reaches a high level, the stability of the slide mass depends mainly on C, while the influence of ? becomes smaller than C.

关键词： impervious bed, rainfall infiltration, pore water pressure, landslide experiment, displacement monitor, discrete element method.

Application of three-dimensional discrete element face-to-face contact model with fissure water pressure to stability analysis of landslide in Panluo iron mine

在线全文

学校读者我要写书评

暂无评论

Science China(Technological sciences) 2005年第z1期48卷 146-156页

作者： ZHANG Lei1,2. WEI Zuoan1, LIU Xiaoyu1 & LI Shihai1 1.Institute of Mechanics, chinese academy of sciences, Beijing 100080, China 2.{3. {2., chinese academy of sciences, Beijing {4., China chinese Acad Sci Inst Mech Beijing 100080 Peoples R China chinese Acad Sci Grad Sch Beijing 100060 Peoples R China

Three-dimensional discrete element face-to-face contact model with fissure water pressure is established in this paper and the model is used to simulate three-stage process of landslide under fissure water pressure in the opencast mine, according to the actual state of landslide in Panluo iron mine where landslide happened in 1990 and was fathered in 1999. The calculation results show that fissure water pressure on the sliding surface is the main reason causing landslide and the local soft interlayer weakens the stability of slope. If the discrete element method adopts the same assumption as the limit equilibrium method, the results of two methods are in good agreement; while if the assumption is not adopted in the discrete element method, the critical φ numerically calculated is less than the one calculated by use of the limit equilibrium method for the sameC. Thus, from an engineering point of view, the result from the discrete element model simulation is safer and has more widely application since the discrete element model takes into account the effect of rock mass structures.

关键词： face-to-facecontactmodel, fissure water pressure, three-dimensional discrete element method,landslide.