咨询与建议

看过本文的还看了

相关文献

该作者的其他文献

文献详情 >Controlled excitation of ultra... 收藏
Controlled excitation of ultrasonic transducers

Controlled excitation of ultrasonic transducers

作     者:Arno VOLKER Maurits VAN DER HEIDEN 

作者单位:TNO Science and Industry Stieltjesweg 12628 CK DelftThe Netherlands 

会议名称:《17th World Conference on Non-Destructive Testing》

会议日期:2008年

学科分类:08[工学] 0804[工学-仪器科学与技术] 

关 键 词:Sweep Resolution Signal to noise ratio 

摘      要:正The reproducibility of ultrasonic measurements complicates the interpretation of measurement *** signal from ultrasonic transducers varies for to several reasons,like manufacturing tolerances in a batch,cable length,amplifier properties etc.A known problem that is caused by this effect is the quantitative interpretation of C-scan images from laminates,particularly the porosity present in a *** this type of application,one requires a high level of signal fidelity,or in other words,system independent measurements. Ultrasonic transducers are commonly excited by a short electrical pulse,such that the temporal bandwidth of the transducers determines the shape of the ***,we propose to use an optimized sweep signal,such that after correlation the measured signal has a desired wavelet *** correlation is done with a specially designed correlation signal instead of using the transmitted *** the design process of the sweep and correlation signal,the transfer function of the system,i.e.,transducer and electronics is measured and transformed into a desired response independent of a specific transducer. This approach yields several advantages over conventional excitation,i.e.,it provides higher temporal and spatial resolution,a better signal to noise ratio and allows system independent ultrasonic measurements. The controlled excitation makes it possible to widen the frequency spectrum of a transducer by boosting the signals at frequencies where the transducer has a lower sensitivity.A bandwidth up to 150% is not difficult to achieve with this technique. The length of the sweep determines the signal to noise ratio,the correlation process has the same effect as averaging of signals,only it is much more efficient in *** up to 30 dB can be achieved compared to single pulse excitation.

读者评论 与其他读者分享你的观点

用户名:未登录
我的评分