咨询与建议

看过本文的还看了

相关文献

该作者的其他文献

文献详情 >Measurements of the Electrical... 收藏

Measurements of the Electrical Incidence Angle Modifiers of an Asymmetrical Photovoltaic/Thermal Compound Parabolic Concentrating-Collector

作     者:Bernardo Ricardo Davidsson Henrik Gentile Niko Gomes Joao Gruffman Christian Chea Luis Mumba Chabu Karlsson Bjorn 

作者机构:Energy and Building DesignLund UniversityLundSweden Solarus Sunpower ABStockholmSweden Finsun ABAlvkarlebySweden Universidade Eduardo MondlaneMaputoMozambique University of ZambiaLusakaZambia Division of Energy EngineeringMalardalen UniversityVasterasSweden 

出 版 物:《Engineering(科研)》 (工程(英文)(1947-3931))

年 卷 期:2013年第5卷第1期

页      面:37-43页

学科分类:1002[医学-临床医学] 100214[医学-肿瘤学] 10[医学] 

基  金:The Swedish International Development Cooperation Agency 

主  题:CPC-collector PVT hybrid incidence angle modifier asymmetric collector electrical efficiency 

摘      要:Reflector edges, sharp acceptance angles and by-pass diodes introduce large variations in the electrical performance of asymmetrical concentrating photovoltaic/thermal modules over a short incidence angle interval. It is therefore important to quantify these impacts precisely. The impact on the electrical performance of the optical properties of an asymmetrical photovoltaic/thermal CPC-collector was measured in Maputo, Mozambique. The measurements were carried out with the focus on attaining a high resolution incidence angle modifier in both the longitudinal and transversal directions, since large variations were expected over small angle intervals. A detailed analysis of the contribution of the diffuse radiation to the total output was also carried out. The solar cells have an electrical efficiency of 18% while the maximum measured electrical efficiency of the collector was 13.9 % per active glazed area and 20.9 % per active cell area, at 25 °C. Such data make it possible to quantify not only the electrical performance for different climatic and operating conditions but also to determine potential improvements to the collector design. The electrical output can be increased by a number of different measures, e.g. removing the outermost cells, turning the edge cells 90°, dividing each receiver side into three or four parts and directing the tracking, when used, along a north-south axis.

读者评论 与其他读者分享你的观点

用户名:未登录
我的评分